カタログ >
International Marine >
Interline 975P

Interline 975P
1 / 4ページ

カタログの抜粋

Interline 975P Epoxy Tank Coating PRODUCT DESCRIPTION A two pack, solvent free epoxy tank coating. INTENDED USES A high performance potable water tank coating which can also be used for void spaces, cofferdams and liquid mud tanks. For use at Newbuilding or Maintenance & Repair. Certified to NSF/ANSI Standard 61 PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 2 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Range: 12 - 24 mils dry (12 - 24 mils wet) may be specified depending upon end use. Theoretical Coverage 134 ft²/US gal at 12 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point Part A >214°F; Part B >214°F; Mixed >214°F Drying Information Pot Life Overcoating Data - see limitations REGULATORY DATA Substrate Temperature Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:10/4/2017

カタログの1ページ目を開く

Interline 975P Epoxy Tank Coating CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Potable Water - NSF approved (NSF/ANSI Standard 61) Potable Water Certification issued by external bodies is dependent upon formulation and/or manufacturing site. Based on this, products supplied in different territories may not be approved to all of the standards listed above. Consult your local representative for the system best suited for the surfaces to be protected. When using in potable water tanks, consult the Interline 975P Potable Water Tank...

カタログの2ページ目を開く

Interline 975P Epoxy Tank Coating APPLICATION Mixing Material is supplied in two containers as a unit. Always mix a complete unit in the proportions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with a power agitator. (2) Agitate Curing Agent (Part B) with a power agitator. (3) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Airless Spray Recommended Tip Range 21-26 thou (0.53-0.66 mm) Total output fluid pressure at spray tip not less than 3000 psi (211...

カタログの3ページ目を開く

Interline 975P Epoxy Tank Coating LIMITATIONS This product will not cure adequately below 50°F. For maximum performance the curing temperature should be kept above 50°F and below 104°F. Thinning is not allowed. The climatic conditions within the tank must be controlled to maintain a maximum relative humidity of 50% at temperatures between 50-59°F, and a maximum relative humidity of 60% at temperature of 59°F and above. The drying times and overcoating intervals may alter due to various on-site factors such as tank configuration and ventilation rates. Maximum overcoating intervals may need...

カタログの4ページ目を開く