Interline 850
1 / 4ページ

カタログの抜粋

Interline 850 Epoxy Phenolic Tank Coating PRODUCT DESCRIPTION A two pack, high solids, epoxy phenolic coating. INTENDED USES A tank coating which is approved for the carriage of potable water. For use at Newbuilding or Maintenance & Repair. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 4.00 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 244 ft²/US gal at 5 mils dft, allow appropriate loss factors Airless Spray, Roller, Brush Flash Point Part A 108°F; Part B 129°F; Mixed 109°F Induction Period 15 minutes at temperatures below 59°F Drying Information Overcoating Data - see limitations REGULATORY DATA 225 g/lt (1.88 lb/US gal) as supplied (EPA Method 24) 143 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 1.44 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:11/9/2

カタログの1ページ目を開く

Interline 850 Epoxy Phenolic Tank Coating CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Potable Water - Carriage of Potable Water (Folkehelseinstituttet, Norway) • Potable Water - Certification for tanks greater than 40,000mm²/lt (AS / NZS 4020 : 2005) • Potable Water - Carriage of Potable Water (TUV, Singapore) (BS6920:2000) Consult your International Paint representative for details. Potable Water Certification issued by external bodies is dependent upon formulation and/or manufacturing site. Based on this, products supplied in...

カタログの2ページ目を開く

Interline 850 Epoxy Phenolic Tank Coating APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. International GTA220, GTA415. Thinning is not normally required. Consult the local representative for advice during application in extreme conditions. Do not thin more than allowed by local environmental legislation. Airless Spray Recommended Tip Range 21-27 thou...

カタログの3ページ目を開く

Interline 850 Epoxy Phenolic Tank Coating LIMITATIONS UNIT SIZE When used in cargo tanks Interline 850 should not be applied below 50°F. However, for potable water tanks, Interline 850 may be applied at steel temperatures down to 41°F. Consult International Paint for specific cure schedules. The drying times and overcoating intervals may alter due to various on-site factors such as tank configuration, ventilation rates, etc. The tank should be flushed adequately with potable water prior to filling. Discoloration of the coating may occur during washing, depending on the ionic content (eg:...

カタログの4ページ目を開く