Intergard 821
1 / 4ページ

カタログの抜粋

Intergard 821 Epoxy Filler PRODUCT DESCRIPTION A two pack epoxy filler. INTENDED USES For use as an anode shield and as a filler for pitted steel. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 1.00 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness 6000 microns dry (6000 microns wet) for use as an Anode Shield, up to 20,000 microns may be used as a filler Theoretical Coverage 0.17 m²/litre at 6000 microns dft, allow appropriate loss factors Flash Point (Typical) Part A 65°C; Part B 62°C; Mixed 62°C Induction Period Drying Information Overcoating Data - see limitations Overcoated By Intergard 821 Note REGULATORY DATA May be overcoated with Intergard and Intertuf products, consult International Paint for specific recommendations. 74 g/lt as supplied (EPA Method 24) 126 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 48 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:04/12/201

カタログの1ページ目を開く

Intergard 821 Epoxy Filler SYSTEMS AND COMPATIBILITY Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. ANODE SHIELDS NEWBUILDING/MAJOR REFURBISHMENT Where necessary, remove weld...

カタログの2ページ目を開く

Intergard 821 Epoxy Filler APPLICATION Other Knife or Trowel Combine 1 part EAA820 with 1 part EAA821 by volume and thoroughly mix to a uniform colour. Mix only the amount that can be used within the pot life. Airless Spray Conventional Spray Work Stoppages and Cleanup Monitor material conditions, do not exceed pot life limitations. Clean all equipment immediately after use with International GTA822. In the event welding or flame cutting is performed on metal coated with this product, dust and fumes will be emitted which will require the use of appropriate personal protective equipment and...

カタログの3ページ目を開く

Intergard 821 Epoxy Filler LIMITATIONS This product will not cure adequately below 5°C. For maximum performance the curing temperature should be above 10°C. In humid conditions, the surface of Intergard 821 may develop a "sweat" which must be washed off with fresh water before overcoating. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at...

カタログの4ページ目を開く