カタログ >
International Marine >
INTERGARD 7600 DATA SHEET

INTERGARD 7600 DATA SHEET
1 / 4ページ

カタログの抜粋

Pure Epoxy Universal Primer PRODUCT DESCRIPTION INTENDED USES PRODUCT INFORMATION A light coloured, pure epoxy universal primer with good abrasion resistance and anticorrosive properties. Suitable for application at low temperatures (down to 23°F). As a universal primer which can be applied directly to mechanically prepared shop primer. Suitable for use with controlled cathodic protection. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point 3 volume(s) Part A to 1 volume(s) Part B 5 mils dry (7.4 mils wet). Range 4 - 8 mils dry (5.9 -11.8 mils wet) may be specified depending upon end use. 218 ft2/US gal at 5 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Part A 82°F; Part B 81 °F; Mixed 84°F Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 298 g/lt (2.49 lb/US gal) as supplied (EPA Method 24) 203 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

カタログの1ページ目を開く

Pure Epoxy Universal Primer SURFACE PREPARATIONS When used as part of an approved scheme, this product has the following certification: • Fire Resistance - Marine Equipment Directive compliant • Fire Resistance - Surface Spread of Flame (WFR) - (IMO Resolution A653 (16)) • Fire Resistance - MSC61 (67) Smoke & Toxicity (WFR) • Food Contact - Carriage of Grain (NOHA) Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. Use in accordance with the standard Worldwide Marine...

カタログの2ページ目を開く

Pure Epoxy Universal Primer Airless Spray Work Stoppages and Cleanup Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray...

カタログの3ページ目を開く

Pure Epoxy Universal Primer Intergard 7600 should be high pressure fresh water washed and/or solvent washed prior to overcoating, where necessary, to ensure removal of any surface contamination that has accumulated. Intergard 7600 may be applied at substrate temperatures down to 23°F, however consideration should be given when overcoating at low temperatures as the remainder of the system may require higher temperatures to achieve full cure. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions....

カタログの4ページ目を開く