Interfine 878
1 / 4ページ

カタログの抜粋

Interfine 878 Polysiloxane Finish PRODUCT DESCRIPTION A patented high performance, high volume solids content acrylic polysiloxane cosmetic finish providing excellent long term durability. Interfine 878 significantly improves upon the gloss and color retention exhibited by typical polyurethane finishes. INTENDED USES As a cosmetic finish on above water areas. For use at Newbuilding and Major Refurbishment. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 5 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 385 ft²/US gal at 3 mils dft, allow appropriate loss factors Air Spray, Airless Spray, Brush, Roller Flash Point Part A 93°F; Part B 131°F; Mixed 95°F Drying Information Overcoating Data - see limitations REGULATORY DATA 246 g/lt (2.05 lb/US gal) as supplied (EPA Method 24) 194 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 1.68 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:2/22/2021

カタログの1ページ目を開く

Interfine 878 Polysiloxane Finish CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Fire Resistance - Marine Equipment Directive compliant • Fire Resistance - Surface Spread of Flame (Exova Warringtonfire) • Fire Resistance - Smoke & Toxicity (Exova Warringtonfire) Consult your International Paint representative for details. Interfine 878 must be applied over a recommended primer system, which will vary depending upon the vessel area. Direct application is acceptable over the following marine anticorrosives: Intershield 300 Intergard 787...

カタログの2ページ目を開く

Interfine 878 Polysiloxane Finish APPLICATION Mixing Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. After mixing Part A and Part B a slight exotherm may be noted, which is typical of this product, and is a result of chemical reaction. International GTA007. Thinning is not normally required....

カタログの3ページ目を開く

Interfine 878 Polysiloxane Finish LIMITATIONS UNIT SIZE Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. The optimum curing conditions for Interfine 878 are between 40% and 85%, curing times may vary outside these parameters. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F, unless...

カタログの4ページ目を開く