Interbond 808
1 / 2ページ

カタログの抜粋

Tar free surface tolerant light coloured epoxy Product Description A light coloured, tar free, surface tolerant, two pack epoxy coating with high volume solids (82%). Interbond®808 can be applied as a one or two coat system over grit blasted, mechanically prepared shop primer, hydroblasted or mechanically cleaned surfaces. It is tolerant of damp surfaces. A high performance epoxy coating for use in water ballast tanks, cofferdams, void spaces, wet spaces, bilges and crude oil tanks. For use at Newbuilding, Maintenance & Repair and On Board Maintenance. Two component epoxy formulation containing aluminium pigment Long term anticorrosive performance Light colour Aids inspections and working conditions Health and safety benefits for the applicator Independent proof of performance Surface tolerant/damp tolerant Control of surface preparation costs Can be applied to damp surfaces, providing flexible scheduling, especially at sea Short time to immersion Rapid service entry Control of solvent emissions Meets regulatory requirements Excellent condition in the water ballast tank after 15 months Excellent condition in the water ballast tank after 38 months Product Information Colour Surface preparation All surfaces to be coated should be clean and free from contamination* Volume solids Typical film thickness 300 microns dry (366 microns wet) 2x160 microns dry (195 microns wet) for IMO PSPC ballast tanks Minimum application temperature 5ºC Method of application Airless Spray, Brush For each of our products the relevant Product Data Sheet, Material Safety Data Sheet and package labelling comprise an integral information system about the product in question. Copies of our Product Data Sheets and Material Safety Data Sheets are available on request or from our website. *For IMO PSPC ballast tanks consult International Paint. Wing tank - excellent condition after 48 mont

カタログの1ページ目を開く

Damp Tolerance Repair Sequence Condition of ballast tanks prior to work commencing There are no scientific or electronic means of determining whether a surface is damp or wet. International Paint’s unique V test is a simple, quick assessment to evaluate whether a surface can be coated. If water collects at the bottom of the “V” the surface must not be coated. Time to Ballast TEMP (¼F) 41 TIME (DAYS) Fast time to ballasting of Interbond®808 allows rapid service entry. 2.5 Hydroblasted and corrosion removed then high pressure freshwater washed Fast time to ballasting 24 hours at 25ºC Touch up...

カタログの2ページ目を開く