カタログ >
Eaton >
Admiral SS specifications

Admiral SS specifications
1 / 9ページ

カタログの抜粋

GENERAL SPECIFICATICI

Marina Power and Lighting, Inc. General Specifications for the Admiral SS – 14 Inch – Power Pedestal All Power Pedestals Must Meet the Following: Part I. General: 1.1 General RequirementsA.) Shall be tested and certified to be in compliance with ANSI/UL 231 entitled “power outlets.” B.) If a laboratory other than U.L. is used that laboratory must certify, in writing, that the power outlet has been tested and meets all of the requirements of ANSI/UL 231, including 746C polymeric materials, and that the unit will pass the 94VO-5V flame test. C.) Shall be certified to meet all sections of NFPA...

カタログの2ページ目を開く

D. Loop Feed Buss Bar System: 1. The buss system shall be of stud compression terminal type using a 3/8” – 16 silicon-bronze stud with a silicon-bronze Belleville type washer. The 3/8” – 16 silicon-bronze hex-nut shall be torqued to 200 inch-pounds. 2. Two separate access areas shall be provided with individual access panels. There shall be one access area for each electrical phase – one for the 240V, single phase supply, and one for the 208V, three phase supply. These access areas shall be separated by a phase isolation plate. E.) Grounding: 1. All exposed metallic parts must have an...

カタログの3ページ目を開く

2. Circuit breakers for the 120/240V, 100 amp pin and sleeve receptacles shall be a two pole 120/240 volt, 100 amp thermo-magnetic type. 3. Circuit breakers for the 120/208V, 100 amp pin and sleeve receptacles shall be a three pole 120/208 volt, 100 amp thermo-magnetic type. E.) Metering: 1. The pedestals shall be equipped with fully electronic meters that display the kilowatts used at each slip on a non-resettable digital counter that is protected from the weather. The accuracy of the meters must be certified by the manufacturer to have a 200 ampere rating and no more than a 2% error when...

カタログの4ページ目を開く