Portholes
1 / 16ページ

Omega Portholes manual Crafted with craftsman marine Deck Equipment

Thank you very much for purchasing (a) Craftsman Marine porthole(s). You have made an excellent choice and our Craftsman Marine Service Team will gladly be of the best possible assistance, if and when you will need us. The portholes made by Craftsman Marine are designed and developed by engineers who are fully aware of all requirements in a marine environment; professionals who know of the ultimate quality demands, whilst making the best use of their many years of experience. Enjoy boating with your Craftsman Marine products on board. Craftsman Marine B.V. Here below you will find a survey...

1. Huide for M4 bolt length selection 12 2. Hinge - pre-tension adjustment Procedure 13

Craftsman Marine portholes are made of special, seawater resistant aluminium profiles, polished by hand to eliminate the surface pores (no collection of dirt) and thereafter anodized. The panes are made of unbreakable acrylic of 10 mm thickness. Colour: smoke grey. The hinges and clamps are made of synthetic and other non-corrosive materials. Craftsman Marine portholes are CE-certified, class A2. crafted with CRAFTSMAN MARINE

This manual applies to the following Craftsman Marine portholes:

Safety precautions Take the required safety measures when fitting this equipment, especially while cutting into the hull: smoke, dust and glass fiber particles should be avoided by wearing goggles, a dust mask and gloves. Keep all portholes firmly closed while boating! Practical Tips The porthole may only be used for inward opening of the pane. Make sure that the portion of the hull into which the porthole is fitted will be absolutely flush and not curved or dented, so as to ensure proper water-tightness. Use Marine -grade sealant and apply it liberally onto the inside of the outer flange....

1. Mark the cut-out portion by using the template. 2. Cut the hole using a jigsaw, and deburr the edges. crafted with CRAFTSMAN MARINE 3. Apply sealant onto the fitting edge.

4. Verify proper fitting and press the porthole firmly into the hole, so that the sealant is forced from the gap. 5. Position the inner frame and fasten the screws evenly; do not over-tighten. crafted with CRAFTSMAN MARINE

1. Guide for M4 Bolt length selection 12 crafted with [RHFTSmnn marine

2. Hinge - pre-tension adjustment procedure - The hinges are factory adjusted and in most cases do not require further adjustment on site. - Use a socket spanner to tighten the nuts at both ends, so that they just touch the washers. Do not over-tighten! crafted with CRAFTSMAN MARINE

Maintenance 10Safety precautions: Maintenance Opening: Turn the clamps a quarter turn to the left and pull the clamps Use only genuine Craftsman Marine spares. outward to open the window pane. The window pane will remain Clean anodized aluminum profiles only with neutral and non abrasivecleaning agents. open in any position you may choose. Closing: Ensure that the clamps are in the "open" position. Push the window closed and turn the clamps a quarter turn to the right. Adjust extra compression by adding 1 revolution counterclockwise extra. 14 crafted with [RHFTSmnn marine

crafted with CRAFTSMAN MARINE

info@craftsmanmarine.com www.craftsmanmarine.com crafted with craftsman marine