| | | | | | | | |
| | | |
| | All VETUS power hydraulic systems use a variable and adjustable piston pump, which operates according to the constant pressure principle. This type of pump continuously varies its output to provide the ideal balance between the required flow rate and the maximum operating pressure ("load sensing"). If no hydraulic flow is required, the pump will simply freewheel, in which case the power drain and wear and tear will be negligible. | |
| | | |
| | LOW NOISE PUMPS (WITH CAST IRON BODY) | |
| | | |
| | | | |
| | | |
| | Capacity Sense of rotation Connection | : 62 cc : Left handed. : SAE-B flange, 13 spline shaft. Rear connection for suction and pressure. Fits VETUS DEUTZ engines and PRM gearboxes. : 2.880 | Capacity Sense of rotation Connection | : 45 cc : Left handed. : SAE-B flange, 13 spline shaft. Rear connection for suction and pressure. Fits VETUS DEUTZ engines and PRM gearboxes. : 2.800 | |
| | | | |
| | | |
| | | | | |
| | | |
| | Capacity Sense of rotation Connection | : 62 cc : Right handed. : SAE-B flange, 13 spline shaft. Side connection for suction and pressure. Fits Twindisc gearboxes. : 2.880 | Capacity Sense of rotation Connection | : 30 or 45 cc : Left handed. : SAE-B flange, 13 spline shaft. Side connection for suction and pressure. Fits PRM gearboxes. : 3.600 SD1 2.800 SD2 | |
| | | | |
| | | |
| | | |
| | | |
| | | | |
| | | |
| | Capacity Sense of rotation Connection | : 75 cc : Left handed. : SAE-C flange, 14 spline shaft. Side connection for suction and pressure. Fits Twindisc gearboxes. : 2.880 | Capacity Sense of rotation Connection | : 30 or 45 cc : Right handed. : SAE-B flange, 13 spline shaft. Side connection for suction and pressure. Fits Twindisc gearboxes. : 3.600 SD1 2.800 SD2 | |
| | | |
| | For John Deere engines, pump model HT1027 has an extension shaft, for connection to the water pump. | | |
| | | |
| | WHICH PUMP IS REQUIRED FOR MY ENGINE? In order to determine this, the manufacturer's specification for the engine must be consulted. if the engine or the gearbox is provided with a Power Take Off (P.T.O.), the smaller hydraulic pumps may be connected directly to it via the SAE - B flange. If no P.T.O. is available, please consult Vetus. Pump models HT1015 to HT1017 all have a SAE -B flange with different rotation and hose connection possibilities. Model HT1022 has a SAE-C flange and is designed for belt drive with a bearing block. We can supply the required supports. One pump can be used to power various hydraulic devices on board for boat. | DIAGRAM OF A SINGLE HYDRAULIC DRIVE It is possible to connect various equipment devices to one hydraulic pump. Ai | |
| | 1. Hydraulic motor 2. High pressure pump 3. Solenoid control valve 5. Hydraulic pump 6. Storage tank hydraulic fluid | | |
| | | |
| | | | | |
| | | |
| | | | | | | | |