Fridges & Freezers Boxes STAINLESS STEEL

SERIE MS

Series 3. INSTALLATION 3.2 Doors/handles

HANDLE HOOK-UPAND SETTING

1

Fridges/freezers have got sui- table holes for the handle and the hook-up. If you change the opening mode, it is necessary to dismount the hook-up from its support and fasten it upsi- de-down, so that the handle is upwards. HOOK-UP SUPPORT HOOK-UP

2

As the hook-up, the handle too is fastened to the fridge/freezer by means of a steel clamp. If you change the opening mode, it is necessary to unfasten the handle from the clamp and fasten it again after having tipped over the clamp. On the door there are some holes to hook the handle support clamp and to open the door both on the right and on the left. HOOK-UP SUPPORT HANDLE IMPORTANT Don’t tighten the screws before having set the handle and the hook-up, so that they are exactly one upon the other. Then it is possible to tighten all the screws.

Handle setting

It is very important that the handle is exactly upon its hook-up: on the contrary the good functioning of the fastening could be impaired and some components could break.

Page