Fridges & Freezers Boxes STAINLESS STEEL

SERIE MS

Series 8. TROUBLESHOOTING 8.1 Troubleshooting

Before calling an Authorized Assist ance Centre , we suggest some checks to solve the most common cases of bad func-tioning, not directly caused by material defects or installation errors.If the system wouldnt work after having checked it, call the nearest Frigoboat Authorized Assist ance Centre .To have some information about the nearest Authorized Assistance Centre, call the Vecoservice (+39.0362.35321) or goto the WEBpage www.frigoboat.itNOTE:Wait one minute: there is up to one minute delay between the power ON and the compressor starting. Allow enough time.8.1 - THE BOX IS TOO COLD OR THE COMPRESSOR RUNS CONTINUOSLY8.1.1 - Turn the thermostat clockwise towards 1. If the box is still too cold with thermostat set at 1, then stop the com-pressor, putting the thermostat to 0 or switching off the fridge switch. Use this switch to make run the compressor for 15minutes every 1 - 3 hours to keep the box at the normal temperature (+2 / -6). The unit must be checked by a FrigoboatAuthorized Service.8.2 - THE BOX IS NOT COLD ENOUGH ALTHOUGH THE COMPRESSOR RUNS NORMALLY8.2.1 - Remove any warm food from the box and let it cool down to ambient temperature before storing it again. 8.2.2 - The door must be perfectly closed and the door gaskets must fit perfectly. Nothing must prevent the door gasketto seal. 8.2.3 - Check that there are no obstructions in the compressor air intake and outlet and the condenser is clean.8.2.4 - When the compressor is running, the fan should run in air-cooled models and the pump should run and the water flow in W models. Otherwise it is necessary to clean the filter.8.3 - THE COMPRESSOR STARTS BUT STOPS ALMOST IMMEDIATELYAFTERWARDS8.3.1 - Check the battery charge. If necessary, charge the battery.8.3.2 - Check that all the connections and the fuse of the battery supply to the Frigomatic are well tightened and not cor- roded. In winter the compressor temperature should be above 0 C. 8.3.3 - Disconnect the F boat terminal from the electronic control. If the compressor runs correctly, check the fan, the pumpor the pump relay as the amperage is too high. As soon as you can, the unit shoul be checked by a Frigoboat AuthorizedAssistance Centre.8.4 - THE COMPRESSOR DOESNT START8.4.1 - There is a delay between the power ON and the compressor starting. Wait one minute.8.4.2 - On the electronic control check that the + and - voltage is 12 V (24V) and the thermostat has been set on 7.

Page

27