8 - TROUBLE SHOOTING

Is the air circulation insufficient? Check that there are no obstructions on the outlet and inlet grills and that the marine air filter is cleaned. Is the air filter dirty? Clean or replace it. Has the heating been working only for few minutes? The resistance protection device is snapped. Check the air circulation, the fan speed and the air filter. If this happens again, call the Assistance Service.6.5 - THE HEATING IS NOTSUFFICIENT- RC VERSION. Select on the control panel for boat the heating mode (HEAT) or AUTO (only for the digital model). Have you selected the correct operational mode? Have you correctly regulated the thermostat? Regulate the temperature on higher values. Is the fan speed too high? Decrease the fan speed or select the AUTO mode for the digital version. Is the air circulation insufficient? Check that there are no obstructions on the outlet and inlet grills and that the air filter is cleaned. Has the compressor been running only for short periods? The high pressure switch device is snapped. Check the air circulation and that there are no obstructions on the openings and on the inlet grill and that the filter is cleaned. Is the air filter dirty? Clean or replace the filter. Doen't the compressor run? The high pressure switch device is snapped more than three times. Check the air circulation. Switch off and then switch on again the system by means of the panel. If this happens again, call the Assistance Service.6.6 - THE SEAWATER PUMPDOESN'TWORK After the necessary checks, replace the F1 fuse with another one with the same dimensions and charge. Is the fuse burned? Is the high pressure switch device snapped? Check the cooling circuit and clean the filter on the sea water intake. If this happens again, call the Assistance Service.
ENGLISH

11