Catalogue Aladain Prime and Tec
www.uwatec.com
print switch display
Page / 48
Contact the
Manufacturer
Where to buy
this product ?
Uwatec - 17790, 152564
/ 48
See other catalogues for Uwatec
Text version of the page

4Functions during the dive

4.1 Immersion If the water contacts are deactivated (->41): Switch on Aladin
® before immersion.If you have chosen the option "Water contacts off" ("set 1" or SmartTRAK),Aladin

WARNING

® will turn on with a delay of up to 1 minute into the dive. This willaffect functioning of the boat computer. Make sure that the computer is on befo- re starting the dive. After immersion, starting at a depth of about 0.8 m (3 ft), all diving functions are monitored, i.e. depthand dive time displayed, maximum depth stored, saturation of tissues calculated, no-stop time or decom- pression prognosis determined, ascent rate controlled and displayed and the correctness of the decom- pression procedure supervised. 4.2 TEC Setting bookmarks During the dive you can create bookmarks in your dive profile by pressing . The logbook iconappears for 4 seconds and an audible signal confirms the creation of the bookmark. These bookmarks will be graphically displayed in the dive profile of SmartTRAK.To visualize the bookmarks on the dive profile, the box "Generate bookmarks"under "Program options" in SmartTRAK must be selected. 4.3 Dive time The whole time spent below a depth of 0.8m (3 feet) is displayed as dive time in minutes. The time above 0.8m (3 feet) is counted as dive time only if the diver descends again below 0.8m (3 feet) within 5 minutes. While the dive time is running, the colons on the right of the figures are flas- hing in one second intervals. Maximum dive time displayed is 199 minutes.If a dive lasts longer than 199 minutes the dive time display startsagain at 0 minutes. Dive time
DEPTH DEPTH DIVE DIVE TIME TIME NO ST NO ST OP OP 4.4 Current depth / O TEC Half time alarm (turn around alarm)

WARNING

If half of the set maximum dive time (->39) has elapsed, an audible signal goes off andflashes for 1 minute. TEC Set dive time has elapsed

WARNING

An audible signal goes off and the dive time starts flashing.
2 % mix Current depth is given in 10 cm increments (1 foot). At a diving depth of less than 0.8 m (3 ft) the display shows <– – –>.The O
DEPTH DEPTH DIVE DIVE TIME TIME DEPTH DEPTH DIVE DIVE TIME TIME NO ST NO ST OP OP S L O W Current depth> Time
2 % mix is diplayed as long as CNS O
2 % = 0 and no ascent speed is indicated. O
2 % mix Nitrogen loading bar

20

III UWATEC ® Aladin ® dive computers
NauticExpo's Virtual Library: PDF Catalogues | Documentation | Boating Brochures | Manuals | Marine directory | Specifications | Characteristics
Search Go
page 1 p.1
page 2 p.2
page 3 p.3
page 4 p.4
page 5 p.5
page 6 p.6
page 7 p.7
page 8 p.8
page 9 p.9
page 10 p.10
page 11 p.11
page 12 p.12
page 13 p.13
page 14 p.14
page 15 p.15
page 16 p.16
page 17 p.17
page 18 p.18
page 19 p.19
page 20 p.20
page 21 p.21
page 22 p.22
page 23 p.23
page 24 p.24
page 25 p.25
page 26 p.26
page 27 p.27
page 28 p.28
page 29 p.29
page 30 p.30
page 31 p.31
page 32 p.32
page 33 p.33
page 34 p.34
page 35 p.35
page 36 p.36
page 37 p.37
page 38 p.38
page 39 p.39
page 40 p.40
page 41 p.41
page 42 p.42
page 43 p.43
page 44 p.44
page 45 p.45
page 46 p.46
page 47 p.47
page 48 p.48
pdf-page pdf ne En 2008-12-49-05