SV27
3Pages

Catalog excerpts

 he completely waterproof camera can be installed in any of the underwater light housings for steel, aluminum or fiberglass hulls. The camera is placed in the housing and fixed with a mounting kit. It offers broadcast quality pictures at 550 TVL color lines of resolution and is 12 VDC. The underwater images can be fed to any number of monitors or plasma screens through out the boat. All maintenance, like the underwater lights is from SV27 technical specifications Power Supply: 12 volt d.c. ——————————————————————— Resolution: 550 TVL color lines ——————————————————————— Dimensions: Thru Hull: 3.15"/180mm x 5.98"/152mm ——————————————————————— Angular View: 64 degree ——————————————————————— Available Transmission Modes: NTSC and PAL A monitor with more than 500 TV lines is recommended. ——————————————————————— Pricing available on request. NOTE: All information is subject to change without prior notice, please confirm details prior to ordering. within the hull. This underwater camera is perfect for viewing the aquatic life, as well as offering safety and security benefits. 1881 W. State Road 84, Bay 102, Fort Lauderdale, FL 33315 USA T. 954 760 4447 Toll Free 1 866 772 0130 F. 954 525 3261 sales@seavision.com www.seavision.com

Open the catalog to page 1

Introduction: BY UNDERWATER LIGHTS USA Congratulations on the purchase of your new underwater camera. Underwater Lights® USA, LLC takes pride in providing well designed, high quality and thoroughly tested products that allow you to "enhance your boating experience". This product can be installed in your vessel for remote viewing, security and safety. General Operating Information: The commercial grade camera used in this product will provide robust and reliable operation under normal operating conditions. A single video output cable can be connected from the camera to most any television or...

Open the catalog to page 2

SV27 Underwater Camera Installation: This Thi product should b i d h ld be installed at l ll d least 152 152mm (6”) b l below the water li b qualified/approved personnel using proper tools and h line by lifi d/ d l i l d materials. The minimum hull thickness is 10mm (0.4”) and maximum is 79mm (3.1”) with an access area of at least 100mm (3.9”) left behind the product for camera removal. After selecting a flat surface, cut a 60mm (2-3/8”) diameter hole through the vessel hull in the desired location. Caution! Check that no electrical wiring, fuel lines, oil lines, water lines etc., pass near...

Open the catalog to page 3