| Sure-Seal™ installation. Detailed ir wills tilth product and •hnuld lie followed closely. 1. Remove shall from transmission coupling. 2. Disassemble and ri-mmi- existing shall sealing system. 3. Remove Ihe hose clamps and old hose from the shaft tog (Stem tube). Discard them. DO NOT RE-USE these components as iticy will run function correctly with the SureSeal'1'. A. Draw the shaft back up against ilic coupling. This will expose that portion of Ihe shaft thai was Ideated under the old hose and stuffing box. 5. Insert the end of Ihe SureSeal™ unit into the ai lieu filed hose and push in as far a- it will go. 6. Position the hose as shown nc\l to the stern tube to determine approximately m here liic lip seal will ride on the shaft. 7. Examine this area carefully. IV Mire I hat it is free of pitting, nicks or surface imperfections which could cause leaking. Clean this area thoroughly. Polish Ihe shaft using 300 grit wet/dry sandpaper or emery etolh working around the shaft. Hue and aft actions could put flats or grooves in the shaft. The assembly may be shifted forward sliglnh f>\ adjusting the position of the hose on Ihe stern luhe at the lime of insiallation. S. Carefully press the seal piolctlor into the front of the SureSeal™. Make certain it covers lhe"lip" portion of |