|
Stand
|
Silvertip_C&L_Resin_TDS - 1 Pages
System Three Resins, Inc.
3500 W. Valley Hwy. N. Suite 105
Auburn WA 98001
TECHNICAL DATA SHEET
Silvertip®
TECHNICAL SUPPORT: 253-333-8118
EPOXY LAMINATING
RESIN SYSTEM
DESCRIPTION:
Silvertip epoxy laminating resinis the liquid resin/hardener member of System Three Resins’ SilverTip Series. It has been
formulated as a system for coating and fiberglassing wooden boats and for the repair of fiberglass parts. Both the resin and
hardener are essentially colorless and cures to a blush-free film. The working time to cure time rato is betterr than most boatbuilding
epoxy resin systems. The cured film is tough and resilient with better heat resistance than other ambient temperature cured
epoxies. SilverTip epoxy is designed as a coating and fiberglassing resin rather than as an adhesive or fairing putty base. For
these applications use other SilverTip Series members: GelMagic for bonding wood, fiberglass and other porous materials, EZFillet as a wood flour filleting putty, QuikFair for fairing, and MetlWeld for bonding metals and other non-porous materials.
Silvertip epoxy has not been evaluated for use with any of the common epoxy fillers and modifiers.
PHYSICAL PROPERTIES:
Resin
Fast Hardener
Slow Hardener
Viscosity @ 25°C(77° F) cps
Density (lb. per gallon)
Color
700
9.47
Colorless
525
8.02
Pale Yellow
620
8.02
Pale Yellow
100
100
N/A
N/A
N/A
N/A
50
43
650
26 min.
3 hours
35°F(2°C)
50
43
675
60 min.
6 hours
55°F(13°C)
MIXED SYSTEM PROPERTIES:
Mix ratio by volume resin/hardener
Mix ratio by weight resin/hardener
Viscosity resin/hardener (cps)
Gel time @ 25° C ( 100 gram mass)
Tack-free time @ 25° C
Minimum recommended
application temperature
Maximum Service Temperature ........................................................................................................................................... 160°F
TYPICAL CURED PROPERTIES:
Tensile Strength, psi (ASTM D638) ....................................................................................................................................... 7,900
Tensile Elongation (ASTM D638) ........................................................................................................................................... 8.0%
Tensile Modulus, psi(ASTM D638) ................................................................................................................................... 390,000
Flexural Strength, psi(ASTM D790) .................................................................................................................................... 13,000
Flexural Modulus, psi(ASTM D790) .................................................................................................................................. 420,000
Heat Deflection Temperature, ° F ............................................................................................................................................ 1 2 8
CompressiveStrength, psi(ASTM D695): at yield ............................................................................................................... 13,000
at failure ...................................................................................................... 26,000
Sizes available:
Resin is packaged in containers from one U.S. quart(32 oz.) to 5-gallon pails.
Hardeners are packaged in containers from one U.S. pint (16 oz.) to 5-gallon pails.
For health and safety information concerning this product, please refer to the MSDS sheets for System Three Silvertip
Laminating Resin and Hardeners. MSDS sheets are available on our website at www.systemthree.com, or by calling or
writing System Three Technical Support.
The information contained herein is based on the data available to us and is believed to be correct. However, System Three Resins, Inc.
makes no warranty, expressed or implied, regarding the accuracy of these data or the results to be obtained from the use thereof. System
Three assumes no responsibility for injury from the use of the product described herein.
HELPING YOU PUT IT ALL TOGETHER
