<
table for boat frame="box" rules="all" border="0" cellspacing="0" cellpadding="0" width="816">
| sailboat top" width="0" height="0"> | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | APPLICATION Surface must be clean and free of oil and foreign matter. Adhesion is very good on stainless steel, bonderized steel, primed steel, wash-primed galvanized sheet metal, and wash-primed aluminum. Airless spray mastic type marine equipment is recommended for application. | | |
| | | |
| | | Airless Spray - 0.043" to 0.051" spray tip, appropriate i.d. material hose, a Graco Bulldog@ Marine pump 30:1 ratio or higher. | | |
| | | |
| | | DRYING 1/32" (32 mils) wet film at room temperature dries hard in 3-4 hours. 9/64" (140 mils) wet film at room temperature dries hard in 24 hours. Where faster drying time is required, use forced ventilation, heat or infrared light for boat. | | |
| | | |
| | | THINNING Product is ready for use as received. If conditions should require thinning, use water sparingly. | | |
| | | |
| | | CLEAN-UP After use, equipment may be flushed with water. | | |
| | | |
| | | PHYSICAL PROPERTIES (TYPICAL) Color Viscosity Solids by Weight Solids by Volume Weight/Gallon Flash Point VOC(EPA Method #24) Non-Bleeding Odor After Drying Chemical Resistance | | Tan Sprayable Mastic Consistency 55% 40.8% 10.95 None 0 Ibs.lgal. (water-based coating) Non-Asphaltic None Resistant to dilute acids, alkali, grease, gasoline, and aliphatic marine oils. Protect From Freezing | | |
| | | |
| | | Latex Emulsion | | |
| | | |
| | | |
| | | Note: DC-3 is not intended for direct outdoor weathering. The weathering resistance of DC-3 can be improved by painting. | | |
| | | |
| | | SOUNDOWN | | |
| | | |
| | | 16 Broadway Salem, MA Tel: 978-745-7000 Fax: 978-745-0900 | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | |