Above the waterlinePre-treatment: Degrease using SEAJET BOATWASH. Rinse with fresh water. Existing paints or fibreglass needs to be sanded to remove small lumps and ‘blebs’ in the paintwork. Flatten back with P180–P280 abrasive paper. Brush off dust and use lint free tack rags to remove remaining traces of dust.

Seajet Speed – Non-Toxic Foul-Release CoatingPainting new boats, bare areas and unpainted boats

Pre-treatment Best results will be obtained by removing existing coatings. Follow pre-treatment advice for the surface you are coating. For steel and aluminium, first apply the recommended epoxy primers. For fibre- glass, apply the specification below after keying the surface with P120–P180 abrasive paper. No. ofProduct nameCoating intervalThinner/Abrasive Comments Coatsat 10°C min/maxCleanerPaper1Seajet Universal24 hrs/14 daysThinner U320 dry Usewhenan PrimerUndercoatundercoatis required 2–3Seajet Unythane48 hrs/NoneThinner U400 wet or Topcoatfiner No. ofProduct nameCoating intervalThinner/Abrasive Comments Coatsat 10°C min/maxCleanerPaper1Seajet Speed18 hrs/3 daysThinner ANoneBinder Coat Then 2–3SeajetGlosskeep24 hrs/NoneThinner U400 wet or Topcoatfiner 1Seajet 11718 hrs/7 daysThinner E320 dry Or or two component, high performance ï¬�nish over bare ï¬�bre-glass ForSafetyRacingMarksonthekeelandrudder,applySeajetSpeedBinderCoat,FluorescentOrangeoverawhitebasecoatofSeajetSpeedBinderCoat Leave to harden for 48 hours before launching.Maximum interval before 2–3Seajet Speed7 hrs/NoneThinner ANone Usewhenan launching is 6 months. Multipurposeundercoat isEpoxyrequired 2–3Seajet 13212 hrs/NoneThinner P400 wetPolyurethaneor finer

Re-painting of existing Seajet Speed

Then Pre-treatment Wash with fresh water and a sponge or low pressure fresh water. Carefully sand any damaged areas with P120–P180 abrasive paper. Do not sand in intact areas. Prime as above on bare areas only, then re-paint using Seajet Speed. Topcoat No. ofProduct nameCoating intervalThinner/Abrasive Comments Coatsat 10°C min/maxCleanerPaper2Seajet Speed7 hrs/NoneThinner ANone Leave to harden for 48 hours before launching.Maximum interval before launching is 6 months. Note: Care needs to be taken when applying Seajet Speed.Avoid contaminatingabove water areas by ï¬�rst masking them.Apply by brush or roller. Spray application should only be attempted by professionals.
Seajet Speed after one year in the Caribbean (the aft is still to be power washed) 40

www.seajetpaint.com Helpline01692 406 822

41