SCUBA - Component assemblies (EN 250 : 2000) The Scuba may consist of separate compo-nent assemblies, such as:Cylinder assembly, Regulator, Pressuregauge, Support-transport system. Cylinder assembly defines the assembly ofcylinder body, valve and tank boot, if any. The compressed air contained in the cylin-der assembly shall comply with the requi- rements for breathable air defined in EN 12021 : 1998 The Seac Diving Pro regulators describedin this handbook are to be used in the SCUBA assembly and are certified in com- pliance with European Directive 89/686/EC and standard EN 250 : 2000.

Reference to European Standard EN 250: 2000

PURPOSE - DEFINITIONS - LIMITS SCUBA Definition: The purpose of the requirements and testsspecified by standard EN 250: 2000 is to en- sure a minimum safety level for the operation of Self-Contained Underwater Breathing Ap- paratus (SCUBA) at a maximum depth of 50 meters. Compressed-air open-circuit underwater breath-ing apparatus contained in a cylinder.
ENGLISH SCUBA - MINIMUM EQUIPMENT REQUIRED(EN 250 : 2000) 1.Cylinder body and valve assembly (cylinderassembly)2.Regulator 3.Pressure gauge or pressure control, reserveor alarm device4.System for cylinder support, transport andconnection to the diver (back-piece and/or straps)5.Head equipment (mouthpiece or completemask or diving helmet)6.Instructions for use

Warning!

The following instructions shall be integrated with the ones relevant to the other compo- nents of your SCUBA. Before using your SEAC SUB regulator, read carefully all the instruc- tions for use contained in the relevant hand- books.

CE Certification

The Seac Diving Pro regulators described in this handbook were tested and certified by the notified testing body 0474 RINA, Genoa office (Italy) in compliance with Directive 89/686/EEC of 21 December 1989.Tests were carried out in compliance with stan-dard EN 250: 2000, implementing the above Di- rective, which defines the conditions of sale and the essential safety requirements of Third- Category Individual Protection devices (DPI). Regulators for non-cold waters, having awater temperature equal to or exceeding +10°C Regulators for cold waters, having a watertemperature lower than +10°CIn compliance with standard EN 250 : 2000, CE marking means compliance with the essen- tial health and safety requirements (Ann. II DE 89/686/EEC). Number 0474 near “CE“ identifies the notified testing Body RINA in charge of pro- duction control under Art. 11B DE 89/686/EEC. The certification obtained for the DIAMOND,DIAMOND ICE, and DIAMOND OCTO provides possible use in both of the following categories: waters are considered cold when their tem - perature is lower than + 10 ° C. MARK ON EACH REGULATOR:0474
SEAC SUB 16