SABRE 47 - Sabre Yachts - #1

- Running and anchor lights.

- Stainless steel steering wheel

Length w/o anchor pulpit or swim platform 47'6"/14.48M

Beam......................................... 15'0"/4.57M

Draft.............................................4'5"/1.35M

Deadrise (at transom)...........................14 degrees

Fuel capacity.............................605 US gal/2269L

Water capacity...........................300 USgal/1125L

Holding tank capacity(2-total)..........72 USgal/270L

Headroom (maximum).........................6'6"/2.38M

Sleeping accommodations...............6/6'6"/2.38M

Built to NMMA, ABYC, USCG and CE Category B standards

- Twin Cummins 500 hp QSC 8.3M 6 cylinder, fresh water cooled diesel engines with ETS controls and Smartcraft displays

- ZF IRM 280A marine gears

- 80A12V alternators each engine.

- 2.25" Aquamet shafts and PSS dripless shaft seals.

- Intermediate bearings.

- Seawater cooled 8" exhaust system using Soundown water drop mufflers.

- Manganese bronze struts with rubber cutlass bearings.

- Five blade NiBrAl propellers to ISO class S standard.

- Engine room blower.

- Engine room floor finished with anti-skid material.

- White painted engine room, fully insulated, with Soundown foam noise barrier.

- Engine isolator mounts.

- Automatic fire extinguishing system

- Two aluminum fuel tanks, 605 gallons total.

- Racor fuel filters.

- (2) Deck fill plates. (1) on aft deck (1) on port side.

- Fuel gauging.

- Hynautic hydraulic steering system to both stations.

- Twin bronze rudders.

- Twin Bennett trim tabs.

- Ignition key and start-up panel.

- Cummins ETS electronic controls for shift and throttle.

- Cummins Smartcraft displays for tachometer and hour meter, voltmeter, engine and transmission oil pressure, block cooling water temperature, and fuel level.

- Engine alarms for water temperature and oil pressure.

- Trim tab controls.

- Triple Exalto windshield wipers with washers.

- 5" Ritchie compass.

- Switch controls for horn.

- 50 A 240V AC shore power system on cord reel with 65 foot cord set.

- Illuminated main circuit breaker distribution panel.

- 110V outlets in each cabin, one in engine room. Galley, head, engine room and bridge receptacles are GFI

- Battery charger 50-3 Amp

- 12.5 Kw Onan generator with sound shield.

- Reverse cycle heat/air conditioning in three zones.

- Start-up panel.

- Cummins ETS electronic controls for shift and throttle.

- Cummins Smartcraft displays for tachometer and hour meter, voltmeter, engine and transmission oil pressure, block cooling water temperature.

- Engine alarms for water temperature and oil pressure.

- Bennett trim tab controls.

- Switch controls for horn.

- Running light switches.

- One each AC and DC (GFI) electrical outlet

- Two Group 31DCM dedicated engine starting batteries.

- Two 8D Lifeline 255AH AGM ships batteries.

- Engine battery and emergency crossover switches in engine room.

- Main disconnect panel for engines, ships power, bilge pumps and other systems.

- Illuminated main circuit breaker distribution panel.

- Navigation switch panel at lower helm station.

- Battery condition gauge.

- 12V lighting system 2-way switch controlled at each stairway. Reading lights throughout.

- 12V horn.

- 12V pressure water system.

- Navigation side and stern lights

- Tinned wire throughout.

- Modified "V" hull design with 20 degree deadrise amidships and 14 degrees at transom.

- Hull laminate system with Isopthalic Sport Yacht white NPG gelcoat and vinylester back-up resin.

- Biaxial fiberglass laminate.

- Vacuum bagged Divinycell PVC foam core in running surfaces and topsides.

- Foam/plywood cored fiberglass stringer system.

- Swim platform with low profile ladder.

- Hull side rubbing strakes.

- PVC and stainless steel rub rail.

- Isopthalic gelcoat.

- Biaxial fiberglass laminate with balsa coring.

- Molded in anti-skid deck surfaces.

- 1 1/4" Diameter stainless steel rail/gate system

- Fiberglass bow pulpit with (2) anchor rollers.

SL47