SABRE 42 SEDAN - Sabre Yachts - #1

Sabre 42 sedan

Length (w/o pulpit or swim platform).............42'3"/12.88m

Beam................................................... 14'4"/4.37m

Draft......................................................3'-9"/1.14m

Deadrise (at transom).....................................16 degrees

Displacement (approx., full load)..............30,000 lbs/13.39t

Height to top of optional mast..........................20'3"/6.17m

Height, dwl to top of command bridge rail........13'7"/4.06m

Fuel capacity.......................................450 USgal/1688L

Water capacity......................................160 USgal/600L

Holding tank capacity...............................60 USgal/225L

Headroom (maximum)..................................6'6"/2.38m

Sleeping accommodations............................6/6'8"/2.44m

Built to NMMA, ABYC, CE Category B and USCG standards

Modified "V" hull design with 16 degree deadrise at transom. ISO-NPG Sport Yacht white gel coat and vinylester back-up resin.

Knitted, bi-axial fiberglass laminates. Vacuum-bagged .Divinycell PVC foam core in running

surfaces and topsides. Foam/plywood cored fiberglass stringer system. Fiberglass swim platform with SS telescoping swim ladder. Hinged transom door. Hull side rubbing strakes. PVC rub rail with stainless steel cap. Imron painted, split boot stripe.

Isopthalic gel coat.

Knitted, bi-axial fiberglass laminate with end grain balsa core.

Molded-in anti-skid deck surfaces.

1-1/4" diameter type 316 stainless steel rail system.

Fiberglass bow pulpit with double anchor roller.

Two anchor rode, fender and dock line lockers forward

Lewmar anchor windlass with rope/chain gypsy.

Recessed side deck walkways.

Starboard side sliding door to main salon.

Stainless steel stair with handrail and teak treads to bridge.

(3)Hinged cockpit locker hatches with stainless steel gas struts.

Hinged, inward opening transom door to swim platform.

Flag pole holder and teak staff.

Lewmar Coastline polished aluminum hatches with screens.

Custom stainless steel opening ports with screens.

Custom bow and stern chocks.

Custom stainless steel spring line chocks.

Teak toe rail

Teak cabin side eyebrow. COMMAND BRIDGE

Molded control station console for electronics with storage below.

L-shaped settee with 3" cushions and storage lockers below. Pompanette helm and mate seats, model P2000, 24" pedestals. Oval command bridge table (King Starboard). Stainless steel perimeter hand rail. Plexiglass windscreen.

Built-in fiberglass helm footrest in bridge face.

Twin Yanmar 6LY-3ASTP 440 hp 6-cylinder electronic diesels, fresh water cooled. Includes Yanmar electronic controls

ZF IRM 280 A-2 marine gears.

80-amp, 12-volt alternator on each engine.

2" Aquamet 22 stainless steel shafts.

PSS drip-less shaft seals.

4-blade NiBrAl propellers to ISO Class S standards. Groco engine intake strainers.

Sea water cooled exhaust system with in-line mufflers and side

exhaust outlets. Manganese bronze struts with rubber cutlass bearings. Engine room blower.

White painted engine room. Fully insulated with Soundown foam noise barrier.

T shaped aluminum fuel tank.

Racor fuel/water separators with water level alarms.

Fuel fill plate on starboard side deck

Fuel shut-off valves under cockpit step.

Electric fuel tank level indicator at lower station.

Teleflex hydraulic steering system lower and upper stations. Twin bronze rudders with bronze stuffing boxes. Twin Bennett drop-fin trim tabs (12"x30"x3") with dual actuators.

Start/stop rocker switches with ignition circuit breaker.

Yanmar electronic shift and throttle controls

Digital gauges: Tachometer with hour meter, voltmeter, engine

oil pressure, transmission oil pressure, engine water

temperature.

Engine alarms (light and buzzer) for high water temperature

and low oil pressure. Trim tab controls.

Triple windshield wipers with washers. 4-1/2" Ritchie Navigator compass.

Switch panel with Carlingswitch Contura rocker switches. Includes switches for horn, blower, optional synchronizer, running, anchor and instrument lights, and (3) accessories.

18" Schmitt stainless steel steering wheel with fixed helm pump.

Start/stop rocker switches with ignition circuit breaker.

Yanmar electronic shift and throttle controls

Digital gauges: Tachometer, voltmeter, engine oil pressure,

transmission oil pressure, engine water temperature. Engine alarms (light and buzzer) for high water temperature

and low oil pressure. Trim tab controls. 4-1/2" Ritchie Navigator compass.

Switch panel with Carlingswitch Contura rocker switches. Includes switches for horn, blower, optional synchronizer, running, anchor and instrument lights, and (3) accessories.

18" Schmitt stainless steel wheel with tilt helm pump.

SL42S