OceanLED makes a variety of LED underwater lighting fixtures that require a welded cofferdam to conform to boat ship building standards. All fixtures are Lloyd’s Type Approved before installation. Inquire for further details as these products continue to develop.The Mold IN from OceanLED introduces a totally new concept to customized underwater lighting for fiberglass hulls. The design of the bezel enables a pocket to either be molded or cut into the GRP hull to enable the light to be totally flush with the hull, therefore minimizing drag and thus improving fuel economy etc. The concept was born through the OceanLED technical team striving to achieve Aero- space precision, where research into Lamina flow and drag co-efficient are so crucial to performance. Pockets can be made to accommodate hull angles and maintain a perfectly equal light angle around the entire hull and it is now possible to achieve the ideal 15 degree angle into the water for the very best 3D underwater lighting effects. The Mold IN hails from the same design as the Flush Mount models whereby all cooling is achieved via the cooling rods on the inside of the hull. By using this design, a truly flush sur- face can be achieved resulting in the ultimate in drag co-efficient.Available in 1520, 2010 and 3010 Series in all 4 color options.The Molded Thru Hull follows along the same principal design as the original Thru Hull, where- by there is only a one inch hole penetration in the hull. The molded pocket allows water to flow around the Boat led light enabling sufficient cool- ing.Available in 2010 and 3010 series and all 4 color options. The Cabinet incorporates all the drivers for the LED underwater lights into one serviceable area. Maintaining the Plug & Play system by Deutsch the cabinet, if necessary, can be located up to 500 meters from the actual light!The Driver Cabinet is available in a variety of sizes and power inputs and is temperature controlled using the highest quality dual cooling fans.