PAGE NO.2REPORT NO.17763-1 1.TEST ARTICLE Representativesamples of the listed thru-hulllightassemblies were received for test fromOcean LED LLC Underwater Lights.2.PART NUMBERS 001-500104001-500056001-500061001-500057 001-500058001-500150001-500151001-500152 3.REQUIREMENTS Therequirements for this effort are to perform a mechanical strength test of the lightassemblies per ABYC H-27 determine if the assembly will withstand a 500-pound static force applied for 30 seconds to the inboard end of its connection fitting without failure of the fitting assembly. The load is to be applied in the most vulnerable direction.4.PROCEDURES Thethru-hulllightassemblies were mounted on a ¾? thick simulated boat hull section with the suppliedmounting hardware to hold the assemblies in place.A load of 500 lbs. was applied to the inboard end with each assembly mounted securely on the simulated hull section.5.RESULTS The maximum load of 500 pounds was statically loaded on the end of the each of the lightassemblies with the following results:Part Numberforce appliedduration of testresultcomments 001-500104500 lbs30 secondspass 001-500056500 lbs30 secondspass 001-500061500 lbs30 secondspass 001-500057500 lbs30 secondspass 001-500058500 lbs30 secondspass 001-500150500 lbs30 secondspass* rods bent no casing damage 001-500151500 lbs30 secondspass* rods bent no casing damage 001-500152500 lbs30 secondspass* rods bent no casing damage * test conducted on ends of cooling rods and light casing IMANNA LABORATORY