| | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | Frequently asked questions | | |
| | | Changing latex wrist or ankle seals | | |
| | | |
| | | Obtain a latex seal kit from your Ocean Rodeo dealer. What you need: Ocean Rodeo latex seal kit, sharp scissors, Acetone (or similar product), clean cloth, plastic container (with the same circumference as wrist or ankle opening of boat suit), hot air source (heat gun or hair dryer), small roller. | | |
| | | What do I wear under my drysuit? Ocean Rodeo Drysuits are incredibly versatile. Many people believe drysuits are for cold conditions only...wrong! You can use your drysuit in tropical waters right through to iceberg jumping. How much underwear you use depends on the temperature and your activity level. Typically first time drysuit users bulk up with too much fleece inside their suit. For moderate conditions a 10 ounce fleece pant and shirt is perfect. For warmer conditions you can wear shorts and a t-shirt under the suit, for freezing (snow/blizzard) conditions throw on a second layer of fleece. Will I stay completely dry? Depending on the conditions, and your level of physical output, it is normal to have some condensation on the inner surface of the suit. After a multi-hour session your undergarments may be damp from sweat. Although the suit has been designed to take extreme impacts, some water may enter up the seals during big wipeouts. ^^^F l^^^^B | | |
| | | |
| | | With suit inside out, insert plastic container into wrist or ankle so a portion of the container is exposed past the arm end (must be a snug fit). For necks lay the neck opening over a large ball. | | |
| | | Turn sleeve/ankle/ neck inside out and carefully cut off damaged seal (cut just below seam created when latex seal was originally sewn to the suit). | | |
| | | |
| | | |
| | | Step 1 | | |
| | | |
| | | |
| | | Take your cloth, wet with Acetone, and wipe clean the suit surface around the cuff perimeter. Immediately after this, wipe the exposed adhesive on the tape strip. | | |
| | | Take the strip of dry adhesive tape and remove the paper from one side. | | |
| | | |
| | | Step 3 | | |
| | | |
| | | Step 4 | | |
| | | |
| | | 12 | | |
| | | S | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | |