|
Stand
|
Terminal Strips & Bus Bars - 1 Pages
Terminal Strips & Bus Bars
Terminal Strips
■ Use as a common negative/neutral bus for AC or DC
systems. Dual terminal strips in 4 or 8 screw positions on
3/4" centers are secured to a high density insulated
base. All hardware, bus material and fasteners are
nickel-plated brass,
■ #8 screws accommodate various size ring terminals and
each terminal strip is rated tor 100 amps,
■ Interlocking bases allow use oí multiple terminal strips
and bus bars (described below) to produce secure and
neat wiring assemblies. The terminal strip bases have
provisions tor either #8 or #10 mounting screws, and no
conductive parts in the base are exposed to the
mounting surface,
■ A clear plastic insulating cover is provided with skin
packed units. Specify bulk or skin pack when ordering.
Model
TS-2x4
Total # of Base Terminals
Size
3 1/16" X 1 1/2"
TS-2x8
TS-2x8
16
6 1/16" X 1 1/2"
Interlocking
Feature
Model
BB-2
Qty. of 5/16" Studs
_2_
Base Size
3 1/16" X 1 1/2"
BB-2/8 2 plus 8 - #8 screws
6 1/16" X 1 1/2"
6 1/16"" X 1 1/2"
BB-8
9 1/16"" X 1 1/2"
Interlocking Feature
Bus Bars
■ Ideal as a DC ground tie point or
positive bus, these heavy duty, 500
amp rated bus bar assemblies feature
5/16" studs on 1" centers in 1 /4" thick
copper bar for common connection/
distribution of large wire gauges and
accommodate 5/16" ring terminals,
■ One combination model features two
5/16" studs and eight #8 screws,
accommodating multiple size
wire terminals.
■ All bus material is nickel-plated copper,
■ A clear insulating protective cover is
provided to prevent short circuits and
provide visibility of lugs,
■ The mounting bases are keyed for
interlocking and may be mated with
the terminal strips (described above)
Conductive parts are captured and
recessed away from the mounting
surface. Use #8 or #10 screws for mounting.
Connector Strips
■ Molded nylon encases 6 or 12 pairs of connectors that use screw compression
to secure wires without use of lugs. Ideal for electronic installations. Brass
barrels capture wires and are held in place with a stainless steel "finger"
compressed by a screw. The screw does not make contact with the wires,
protecting the copper strands from cuts and breakage - Meets ABYC
standards. (Same connector strip used in BX Series boxes - see page 26.)
■ 3 Sizes: ranging from 6 to 16 gauge
■ Strips are easily cut to meet wiring requirements and space limitations,
■ All models clamshell packed for attractive retail display, or bulk packed
for contractor use.
Model
CS-1
#of
Terminal Pairs
12_
Max Wire
Gauge
16
Max
Amps*
6
Size
LXWXH
3.75" X .675" X .5"
I
CS-2
12
14
10
4.5" X .75" X .75"
CS-3
12
12
16
5.5" X .875" X .8"
*Per set of terminals
CS-2
DC Power Onboard
Newport Beach, CA USA
www.newmarpower.com ■ 800-854-3906
25
