DANGER! SPECIAL ATTENTION: Be sureall marine spreader fittings are securely attached.The mast will break if the diamond wirescome loose. The mast is not covered underwarranty for breakage due to improper tun-ing, assembly or maintenance. NOTES: The Prindle 18 will have double tra-peze wires on one thimble. When riggingforestay pigtail onto masthorn, the shortwire should be towards mast on Prindle 16and 18, the Prindle 15 will have the forestaywire only, no pigtail. Mast Rotator Shrouds and Trapeze Wires 15 & 18: The rotatorwishbone is bolted tomast using the upperbolts fitted through thediamond tang fittings(no tangs on the 15).This fitting can remainon mast permanently.The lower bolts areused to keep the wish-bone from droppingdown onto boom. Attach twist clip toshroud sailboat pin on deck with1/4” clevis pin. Attachtwist clip to shroudadjuster using another1/4” clevis pin. Toattach shrouds toshroud adjuster, insertshroud thimble inbetween shroudadjuster jaws and insertclevis pin throughadjuster and shroudthimble. Use one of theupper holes in theadjuster. Insert cotterring.Tie a trapeze ring to each of the 3’ lines sup-plied. Thread the line through the thimble atthe end of the trapeze wire. Thread one ofthe plastic height adjusters onto the line,wrapping the line around it at least twice.The adjuster allows you to adjust your tra-peze height. Tie the tail of the line to theshock cord with a bowline.Prindle 15 and 16Single Trapeze Masthorn All boats manufacturer: Take large 5/16” shackle andthread rigging onto masthorn in this order:Trapeze wireShroudForestay pigtail (forestay of 15)ShroudTrapeze wire 12