? Insert the screws inside the handle holes. ? Place the handle on the holes in boat board centre . ? Screw up a little the front screw ? Screw up a little the back screw ? Now you can screw up tight both screw, up to handle is well fixed on surface ? Wash your Kiteboard after every use with sweet water ? Remove Sand from surface and from Pads, Straps, Fins ? When you don’t use your board, place it at the shadow, in a dry place ? Don’t forget your board under the sun : decoration’s colours will decrease and delaminating problems . ? Often check that screws are well tighten. ? Often check the fins status; if the fins crashes against rocks, can be that some sharp part can cut your finger or hands during riding and/or carry on. REPLACE THEM IMMEDIATELY HAS YOU NOTE IT AND DON’T USE THE BOARD UP YOU HAVE REPLACED THEM. Shaping, lamination, finishing are all HAND-MADE operation for a real CUSTOM Board. Material used for your board construction, are at the top on the market. All products are well checked; possible little imperfection on surface are the guarantee of hand made work and them don’t influence for nothing the board performance.