ENGINE FOR BOAT EXHAUST WATER SYSTEM Underwater exhaust system with oversized muffler for noise suppression. Exhaust bypass reduces noise and backpressure and increases fuel efficiency. ENGINE FUEL SYSTEM 200 gallons of fuel onboard with sight gauge on tank. Fuel hoses are type A1 flame resistant, USCG-approved, with pressed drip proof fittings. Single Racor fuel filter for boats /water separator. All shutoff valves accessible from engine room. BILGE SYSTEM Each of the three compartments contains a 2,000 GPH pump with an additional 3,700 GPH high water emergency boat bilge pump located in engine room. All boat pumps have float switches for boats and manual override. All pumps are fitted with one-way valve and anti-siphon loops to reduce water in bilges. An audible high bilge alarm for boats is located at the helm for the engine room bilge pump. POTABLE WATER SYSTEM A 60-gallon polyethelyne water tank is located below the floor. A 6-gallon FRP polyester lined hot marine water heater with combination 240 volt AC and engine heat exchanger heating element. All pressurized marine plumbing is hard-piped. GRAY WATER SYSTEM Direct overboard discharge for boat sinks and shower pump. Shower pump is operated by a switch in the shower with a run-dry 12 V DC pump. BLACK WATER SYSTEM The black water tank is a 35-gallon polyethelyne tank located in engine room. Discharge is via deck pumpout; overboard discharge is optional. WINDSHIELD WIPERS AND WASHERS Three 12 volt windshield wipers with fresh water wash and variable speed controllers. Wipers will autopark. Wipers are pantograph-type with 18” blades. AUTOMATIC FIRE SUPPRESSION SYSTEM Heat activated FM 200 system dispenses environmentally-compliant fire suppression via automatic discharge. Indicator for boats light at helm. AIR CONDITIONING 12,000 btu reverse-cycle with digital controls to heat or cool the area below decks. Three vents—two forward and one in the head.

ELECTRICAL SPECIFICATIONS

GENERAL Electrical marine terminals are double-crimped or waterproof Deutsch connectors. Bulkhead penetrations are foam sealed to isolate each compartment. Thru hull penetrations and sea strainers are bonded to an exterior Dynaplate with 8 gauge wire. Rudders, shafts and trim tabs are independently protected with zinc annodes from corrosion. All wiring is tinned copper and meets or exceeds USCG / ABYC / NMMA standards. GENERATOR FOR BOATS 5 kw Onan generator with sound shield, dedicated start battery and remote start.

3