Hydraulic Follow-Up HFU360-8 - 2 Pages

  1. P. 1

  2. P. 2

Catalogue excerpts

Photo courtesy of Seaspan The HFU360 is a state-of-the-art electro-hydraulic steering system, providing full follow-up power steering with unmatched smoothness, quietness and accuracy for small to-medium size vessels. Hydraulic power may be provided by engine-driven or electric motor driven pumpsets. The HFU360 may be controlled by conventional hydraulic helm pumps, by electric jog levers, and / or by an autopilot. The HFU360 does not require any mechanical feedback linkage. It only requires a small and simple electric feedback unit to be attached to the steering tiller. Should the hydraulic or electric power supply fail a proper manual hydraulic system becomes available automatically instantly connecting the helm pump directly and instantaneously to the main steering cylinders. The steering cylinders are protected by a double-acting relief valve built into the HFU360. The HFU360 is isolated at all times from excessive rudder forces. A rudder lockvalve positively holds the rudder against creep. Wheel rotation is not limited by steering gear speed and may be put hardover in a few seconds. The steering gear follows up to this new position at a rate dependent on the power pump capacity. This results in finger tip steering and greater ease of manoeuvering. In power mode, the number of turns from hardover to hardover can be adjusted. In manual mode, more turns are allowed permitting the helmsman to manually develop full torque, if required, with reasonable wheel effort. Autopilots and jog levers may be electrically connected to the HFU360 allowing for a true customization of the complete steering system in a modular manner. feedback unit

 Open the catalogue to page 1

- TRUE FOLLOW UP control by means of manual helm - SLOW-SPEED ACCELERATION AND DECELERATION over first and last five portion of rudder movement for smooth, accurate and silent operation - TRUE CHANGEOVER to manual steering giving strong and reliable back-up control - FINGER TIP CONTROL with extreme accuracy - HYDRAULIC PROTECTION by double reliefs and load- holding valves - OPTIONAL ELECTRICAL CONTROLS by jog levers or Technical Characteristics: • Power supply: 24 VDC, 6 amps • Output flow rate: 8 gpm (max) • Steering modes: FFU, NFU, manual helm and/or autopilot • Adjustable rudder hardover angle •...

 Open the catalogue to page 2

All Jastram Engineering catalogues and brochures

  1. X Series RAI

    2 Pages

    En
  2. RAI 300 Series

    2 Pages

    En
  3. Analog controls

    3 Pages

    En

Archived catalogues

  1. Catalogue

    47 Pages

    En
  2. Brochure

    28 Pages

    En