28 HATTERAS
60
CONVERTIBLE
STANDARD EQUIPMENT
Exterior Finish/Construction Electrical Systems Flybridge
• Isophthalic gelcoat, exterior layer• Blister-resistant vinylester resin in hull bottom skin coat• Hull and superstructure linear polyester/polyurethane coating• Polymer/copper-based anti-fouling bottom paint• Boot stripe, linear polyester/ polyurethane coating• Decks, non-skid surface, polyurethane paint with polymeric beads, • Solid fiberglass, resin-infused hull bottom• Hull sides and superstructure resin-infused with PVC foam core• Resin infused fiberglass stringers• Steel laminated in stringers at key locations to bolt
marine engine mounts• Engine room bulkheads and decks resin-infused composite construction using PVC foam core with layers of fiberglass laminate on each side • Two 24-volt banks of heavy-duty, 12-volt
marine batteries mounted in fire-retardant fiberglass boxes • Gel/lead acid compatible 240-volt automatic/ programmable battery charger, 50/60 Hz• Automatic battery paralleling system with switch at control console• Air conditioning 45,000 BTU (69,000 BTU with enclosed bridge) with reverse-cycle heating, with AC compressors, individually controlled by SMX controls• One 240-volt, 50-amp, transformer-connected retractable shore cord with over-current protection• One 240-volt, 50-amp, transformer-connected fused shore cord with over-current protection• AC and DC light fixtures• AC dimmable lights in master and salon/galley• AC duplex outlets with ground fault protection• Battery control panels with fuses and isolation switches• DC distribution panel with magnetic circuit breakers and battery condition meter• DC distribution panel with magnetic circuit breakers (engine compartment)• DC electronics panel with magnetic circuit breakers (bridge)• AC distribution panel with magnetic circuit breakers• AC switching panel with source selector switches, volt meter, ammeter, frequency meters, generator start/stop controls, interlock selector breakers and voltage boost switch• Systems monitor with programmable logic controller readout, visual and audible signals for engine, alternator, high bilge water, fire warning in engine compartment, fire extinguisher discharge, AC power loss, smoke detectors, battery voltage, 3/4 full holding tank monitor and carbon monoxide detectors• Ground fault protection on AC receptacles and lighting circuits•
Navigation lights• Telephone/CATV inlet• Telephone and CATV shoreline cords, one each• Omni-directional
Marine tv antenna• U.L. 1426 listed boat cable, tin-coated with insulation• Ventilation fans in attic space • Systems monitor with visual and audible signals for engines and gears, steering cooling pump, high bilge water, fire warning in engine compartment, fire extinguisher discharge, and AC power loss.• Molded fiberglass• Top-loading insulated drink box• Two bench seats with vinyl-covered polyfoam cushions• Rod storage space under forward and starboard bench• Additional storage areas beneath seats and console• Neutral interlock switches allowing engine to start in neutral only• Polished anodized welded aluminum rails and stanchions • Powder-coated grab rails• Control station with all necessary switches and dimmable lighted instrument panel• Engine synchronization control• Compass with dimmable light• Pod console with custom wheel and single-lever clutch and throttle controls (electronic) with emergency back-up and electric trolling valve control switches• Hydraulic power-assisted steering• Twin Murray Sea-19 adjustable teak helm chairs with stainless-steel hardware, footrest and backing plate• Electric fuel level gauges• Audio system control, LCD keypad and a pair of Pioneer Marine waterproof loudspeakers• Icom
VHF, Furuno RD30 depth and temp• 24-volt DC distribution panel• Power-actuated electronics console
Hardware and Miscellaneous Engine Compartment and Bilge
• Water manifold
boat block with centralized shut-off valve for sinks and showers• AC fluorescent lights• DC lights• DC bilge blower• Twin diesel, freshwater-cooled main engines with electrically controlled marine gears, neutral interlocks, exhaust silencers, engine hour meters, alternators, fuel filters and seawater strainers• One 21.5kW freshwater-cooled Electronic Quiet Diesel Onan generator(D) with shock mounts, seawater strainer, remote start, fuel/water separator, hour meter, water lift muffler and sound enclosure.• Variable-speed forced air induction system for engine combustion air with two 15” vaneaxial fans ducted to cockpit and controlled by pressure and temperature (single fan reversible for flow-through ventilation) • Polyethylene water lines• FM200 fixed fire extinguishing system for engine compartment with automatic and remote manual controls, plus audible and visual discharge signals• Pressurized 230-volt AC freshwater pump with central charcoal freshwater filter and back flush capabilities• 230-volt AC 20-gallon electric water
boat heater • Wood bulkheads, cabinetry and trim with a polyester satin finish• All hardware polished chrome with brushed chrome in galley • Fortress FX-55 anchor, anchor line and hawse pipe• Anchor locker bow deck• Two polished stainless-steel stern cleats and hawse pipes, through-bolted in aluminum backing plate• Four polished stainless-steel spring line cleats with chafing strips, through-bolted in aluminum backing plate• Polished stainless-steel bow cleats and chocks with chafing strips, through-bolted in aluminum backing plate• Polished anodized welded aluminum rails on bow, side-deck and flybridge, drilled and tapped in aluminum backing plates • Molded fiberglass grab rails on cabin side and powder-coated rails on flybridge interior • Polished anodized welded aluminum flybridge ladder with acrylic steps•
Fog bell• Zincs on rudders and shafts• Dual air horns• Life ring•
Life jackets (8)
• Freshwater fill hose for engines and generator• 24-volt DC bilge and sump pumps, three at 3700 gph, with heavy-duty float switches and protective guards• Auxiliary emergency
boat bilge pump, 150 gpm in lazarette• Bronze/chrome-plated ball valves through-bolted in solid fiberglass on all
underwater through-hull fittings with electrical bonding throughout• AC compressed air system with air line and regulator• U.L. Marine-listed fiberglass fuel tanks constructed with fire-retardant resin and bronze fittings, and coated with fire-retardant paint • Fiberglass holding tank with bronze fittings• Fiberglass water tanks, constructed with bronze fittings and materials which comply with the requirements of Title 21 for food and drugs.• Sewage holding tank with 24-volt DC sewage pump, plumbed for dockside pump-out with 3/4 full display and alarm, as part of systems monitor programmable logic controller• U.L. Marine-listed fuel filter/water separator, generator• U.L. Marine-listed duplex fuel filters/water separators with bypass manifold, engines• Digital monitoring for main engines in battery panel with start/stop switches.• 110-volt AC reversible oil changing system for engines, gear and generator with Hatteras patented quick disconnect• Electric fuel priming pumps, engines• Electric fuel transfer system with two pumps, providing back-up capability, with filtration and dry tank protection for pump• United States Coast Guard type A1 U.L. Marine-listed fuel lines• Seawater pressure system with AC pump• Air conditioning compressors and pumps• Powder-coated grab rails• Painted polyurethane engine room and bilges• Rubber deck
boat mat between engines
Enclosed Flybridge
(Optional) (F) • Systems monitor with visual and audible signals for engines and gears, steering cooling pump, high bilge water, fire warning in engine compartment, fire extinguisher discharge, and AC power loss.• 24-volt electronics panel• Electric fuel level gauges, forward control station only• Molded fiberglass• Polished anodized welded aluminum rails and stanchions• Polished anodized welded aluminum ladder, cockpit to bridge deck• Elevated L-shaped lounge to port with rod storage
• Black braided nylon
mooring lines (6) • Portable “drychem” and fire extinguishers (4), U.L. approved type in compliance with United States Coast Guard and ABYC standards• Stainless-steel trim tabs• Manganese bronze struts• Stainless-steel rudders with zincs• 5- or 6-blade propellers, Nibral high performance• Alloy 22 high-strength
propeller shafts, 3 1/2 inch, with zincs • Manganese bronze dripless rudder seals with thrust bearing on rudder shaft• Bow deck access to rope storage locker• Black fenders (4)• Reboarding steps to cockpit• Deck plates for fuel and water fills and waste pump out • Heavy-duty bronze engine couplings• Generator exhaust, water separator• Dripless shaft seals with spare seals • Isolated discharge sea chest• Transducer well, glycol filled• Sealed shower sumps• Pultruded fiberglass rudder shelf• 1” stainless-steel steering tie bar with pivoting self-aligning ball joint connection at all cylinder and tie bar connections• Insulation in deck• Pick-up sea chests