STANDARD EQUIPMENT
17 Exterior Finish/Construction
• Isophthalic gelcoat, exterior layer, white• Blister-resistant vinylester resin in hull bottom skin coat• Hull and superstructure linear polyester/polyurethane coating• Polymer/copper-based anti-fouling bottom paint• Boot stripe, linear polyester/ polyurethane coating• Decks, non-skid surface, polyurethane paint with polymeric beads• Solid fiberglass hull bottom• Hull sides and superstructure laminated with PVC foam core• Fiberglass stringers• Steel laminated in stringers at key locations to bolt marine engine mounts• Engine room bulkheads and decks of resin-infused composite construction using PVC foam core with layers of fiberglass laminate on each side Engine Compartment and Bilge
• Water manifold with centralized shut-off valve for sinks and showers• AC fluorescent lights• DC lights• DC exhaust blowers• Twin diesel, freshwater-cooled main engines with electrically controlled marine gears, neutral interlocks, exhaust silencers, engine hour meters, alternators, fuel filters and seawater strainers• 21.5kW freshwater-cooled Electronic Quiet Diesel Onan marine generator(D) with shock mounts, seawater strainer, remote start, fuel/water separator, hour meter, water marine lift muffler and sound enclosure • Variable-speed forced air induction system for engine combustion air with two 15” vaneaxial fans ducted to cockpit and controlled by pressure and temperature (single fan reversible for flow-through ventilation) • Polyethylene water lines• FM200 fixed fire extinguishing system for engine compartment with automatic and remote manual controls, plus audible and visual discharge signals• Pressurized 24-volt DC freshwater pump with central charcoal freshwater filter and back-flush capabilities• 230-volt AC 20-gallon electric water boat heater• Freshwater fill hose for engines and generator • 24-volt DC bilge and sump pumps: three at 3700 gph, two at 2000 gph and four at 1100 gph, with heavy-duty float switches and protective guards Hardware and Miscellaneous
• Wood bulkheads, cabinetry and trim with a polyester satin finish• All hardware polished chrome with brushed chrome in galley• Fortress FX-55 anchor, anchor line and deck hawse pipe with anchor tensioner• Polished stainless-steel anchor cleat, through-bolted in aluminum backing plate • Two polished stainless-steel stern cleats and hawse pipes, through-bolted in aluminum backing plate• Four polished stainless-steel springline cleats with chafing strips, through-bolted in aluminum backing plate• Polished stainless-steel bow cleats and chocks with chafing strips, through-bolted in aluminum backing plate• Polished anodized welded aluminum rails on bow, side-deck and flybridge, drilled and tapped in aluminum backing plates • Powder-coated grab rails on cabin side and flybridge interior• Polished anodized welded aluminum flybridge ladder with acrylic steps• Fog bell • Zincs on rudders and shafts• Dual air/electric horn• Life ring• Life jackets (6) • Auxiliary emergency bilge pump, 150 gpm in lazarette• Bronze/chrome plated ball-valves through-bolted in solid fiberglass on all underwater through-hull fittings with electrical bonding throughout• U.L. Marine-listed fiberglass fuel tanks constructed with fire-retardant resin and bronze fittings, and coated with fire-retardant paint • Fiberglass holding tank with bronze fittings• Fiberglass water tanks, constructed with bronze fittings and materials which comply with the requirements of Title 21 for food and drugs.• Sewage holding tank with 24-volt DC sewage pump, plumbed for dockside pump-out, with 3/4 full display and alarm as part of systems monitor programmable logic controller• U.L. Marine-listed fuel filter/ water separator, generator• U.L. Marine-listed duplex fuel filters/water separators with bypass manifold, engines• Digital monitoring for main engines in battery panel with start/stop switches.• 24-volt DC oil changing system for engines, gear and generator with Hatteras patented quick disconnect• Electric fuel transfer system with filtration and dry tank protection for pump• United States Coast Guard type A1 U.L. Marine-listed fuel lines• Seawater pressure system with DC pump• Air conditioning compressors and pumps• Painted polyurethane engine room and bilges• Isolated discharge sea chests• Transducer well, glycol filled• Sealed shower sump• Pultruded fiberglass rudder shelf• 1” stainless-steel steering tie bar with pivoting self-aligning ball joint connection at all cylinder and tie bar connections• Insulation in deck• Pick-up sea chests Cockpit
• Molded fiberglass, 126 square feet including 13 square feet of seating• Seating with cushions across upper mezzanine• ISO standard scuppers in cockpit and cockpit hatches• Polished anodized aluminum ladder to flybridge with acrylic steps• Transom door• One 50-amp shoreline electrical inlet and retractable shore cord• One 50-amp shoreline electrical inlet and fixed shore cord• Seawater and freshwater wash down outlets with Hatteras patented quick disconnect• Shore water connection with pressure-reducing valve and Hatteras patented quick disconnect• Bait and tackle drawers, upper starboard mezzanine • Black braided nylon mooring lines (6)• Interceptor trim control• Manganese bronze struts• Stainless-steel rudders with zincs• 7-blade propellers, Nibral high performance• Alloy 22 high-strength propeller shafts, 3-inch, with zincs • Manganese bronze dripless rudder seals with thrust bearing on rudder shaft• Bow deck access to marine rope storage locker• Black fenders (3)• Reboarding steps to cockpit• Deck plates for fuel and water fills and waste pump out• Heavy-duty bronze engine couplings• Dripless shaft seals with spare seals Electrical Systems
• Two 24-volt banks of heavy-duty, 12-volt marine batteries mounted in fire-retardant fiberglass boxes • Gel/lead acid compatible 240-volt automatic/ programmable marine battery charger, 50/60 Hz• Automatic battery paralleling system with switch at control console • Air conditioning, 43,000 BTU, with reverse-cycle boat heating, with A/C compressors, individually controlled by SMX controls• One 240-volt, 50-amp, transformer-connected fused shore cord with over-current protection• One 240-volt, 50-amp, transformer-connected retractable shore cord with over-current protection• AC and DC light fixtures• AC dimmable lights in master and salon/galley• AC duplex outlets with ground fault protection• Battery control panel with fuses and isolation switches• DC distribution panel with magnetic circuit breakers• DC distribution panel with magnetic circuit breakers (engine compartment)• DC electronics panel with magnetic circuit breakers (bridge)• AC distribution panel with magnetic circuit breakers• AC switching panel with voltage source selector switches, volt meter, ammeter, frequency meter, generator start/stop controls, interlock selector breakers and voltage boost switch• Systems monitor with programmable logic controller readout, visual and audible signals for engine, alternator, high bilge water, fire warning in engine compartment, fire extinguisher discharge, AC power loss, smoke detectors, battery voltage, 3/4 full holding tank monitor and carbon monoxide detectors• Ground fault protection on AC receptacles and lighting circuits• Navigation lights• Telephone/CATV inlet• Telephone and CATV shoreline cords, one each• Omni-directional Marine tv antenna• U.L. 1426 listed boat cable, tin-coated with insulation• Ventilation fans in attic space Flybridge
• Systems monitor with visual and audible signals for engines and gears, steering cooling pump, high bilge water, fire warning in engine compartment, fire extinguisher discharge, and AC power loss.• Molded fiberglass • Top-loading insulated drink box• Two bench seats with removable vinyl-covered polyfoam cushions and storage underneath• Rod storage space in port bench seat• Additional storage areas beneath athwartship seat and console• Neutral interlock switches allowing engine to start in neutral only• Polished anodized welded aluminum rails and stanchions • Powder-coated grab rails• Control station with all necessary switches and dimmable lighted instrument panel• Engine synchronization control• Boat compass with dimmable light• Pod console with custom wheel and single-lever clutch and throttle controls (electronic) with emergency back-up and electric trolling valve control switches • Hydraulic power-assisted steering• Twin Murray Sea-19 adjustable teak helm chairs with stainless-steel hardware and footrest, and backing plate• Electric fuel level gauges• AC weatherproof receptacle• Audio system control, LCD keypad and a pair of Pioneer Marine waterproof loudspeakers• Icom VHF, Furuno R030 depth and temp• 24-volt DC distribution panel• Power-actuated electronics console