NOTE
Close bypass valve on fluid section of pump for boats. (Turn clockwise to close). Refer to specific User Manuals for detailed component start-up and shut-down instructions. Before Operating the System 1.
Make sure all hose connections are tight and secure. 2.
Make sure to remove Cap plug from bottom inlet of Material Pump before attaching material pick-up hose. 6.
Connect main air supply to system. (GlasCraft re- commends a minimum of 3/8”dia. airline.) 3.
Fill Lube Cup at the top of fluid section half (½ ) full of suitable pump lube. 7.
Each new GlasCraft system has been fluid tested at the factory. Our pump test solution is red- colored DBP (Di-N-Butyl Phthalate). There may be a re- sidual amount of DBP in system that should be- evacuated before putting the unit into production. During the initial start-up, ½ to 1 gallon of material should be dispensed. This is typically adequate to remove the test material. If desired, the fluid pump can be flushed with a suitable cleaning solution to evacuate DBP before priming with material. 4. 8.
Review all service manuals, which contain detailed operation and safety instructions. Make sure the ball valves on manifold are off and regulators are dialed down to zero. (Turning regu- lators counter-clockwise will dial them down.) 5.

32 Operation