Salt 47’

IV. INTERIOR FITTINGS

Interior arrangements treatment and finishes can be personnalised according to the owner preferences Our design office (architectes, designers and technicians) prepare a detailed specification document, with full technical drawings and can offer a high quality project management service.Interior arrangements are realised in marine plywood and solid wood (maple or other light wood of choice).

FITTING

FLOORS Marine plywood CPM grooved light or dark with lifting system, fixings and joints ISOLATION In order to avoid any risk of condensation, the hull (from waterline to deck), deck and roof are isolated thanks to a closed cell polystyrène foam (styrodur type or equivalent) Frames and sharp edges are protected by a flexible black isolation foam. INNER PLANKING Hull inner planking is marine plywood 5 mm thick covered by a skaï layer on foam. CEILING Marine plywood covered by a layer of skaï on foam BATHROOM (OWNERS CABIN) FORWARD OWNERS CABIN -Access door (with neoprene joint, anti vibration) -Electrical WC (fresh water) -Lower locker with " corian " table or similar, integrating a washbasin -Upper locker with sliding doors and mirrors, "jewel" drawers -Shower with grate or teak lathing on shower tray. -Pressure water mixer tap -Tap and flexible pipe in showerACCESSORIES-Towel rail -WC paper support and brush -Soap dish -Access door (with neoprene joint, anti vibration) -Double central bed with anti-humidity under layer -Drawers and lockers fitted under the bed (with gas jack to facilitate access) -Double wardrobe and cupboards -Bookshelves

C

HANTIER

N

AVAL

G

ARCIA

14