Condensing Unit should be dry and accessible forservice, and provide the most direct routing of refrigerant line sets relative to the evaporator location(s).The vibration isolated condensing unit should be secured to a horizontal surface that is designed for the weight of the unit and torsion loads from the vessel’s movement.Refrigerant-grade copper tubing should be properly sized for the specific application.Both the suction and liquid lines should be insulated separately with approved closed cell foam jackets (i.e., 1/4”wall thickness insulation).The refrigerant line ends should remain capped until the actual connections are made to prevent contamination.To prevent kinks in the tub- ing, which will adversely affect the performance and longevity of the system, tube benders are recommended.When using multiple evaporators with one condensing unit, locate allunions and tee fittings properly in areas accessible for service.Use approved flaring techniques and refrigerant grade components for all con- nections.Insulate fittings using insulation tape (only after system has been leak-checked).Wrap fittings sufficiently to equal R-value of tube insulation. Reinforced marine grade hose should be used for the seawater circuit. All hose fittings should be double clamped.The hose should be routed upward from the thru hull intake to the condensing unit to prevent airlocking.The condensation drain should be connected and routed downward to a proper sump or overboard discharge.All circuit breakers and wire gauge must be sized according to marinedesign standards.Only stranded tinned copper wire should be used.All equipment must be properly grounded.The installed line sets and evaporator(s) must be evacuated to removeair from these components and prevent moisture acidity formation.All con- nections should be properly leak-checked upon releasing the refrigerant charge from the condensing unit into the system.If the system is to be opened for any reason at this point or for future service, the refrigerant charge must be “pumped down”back into the condensing unit or recovered to prevent it from escaping into the atmosphere.Refer to other individual component sheets for specifications anddetails of evaporators, controls and related parts.In keeping with regulations set forth by the EPA, only certified techni-cians should perform service on, or make adjustments to, the refrigerant cir- cuit.Never install your air handler in bilge or engine room areas.Insure thatthe selected location is sealed from direct access to bilge and/or engine room vapors.Do not terminate condensate drain lines within three (3) feet of any outlet of engine or generator exhaust systems, nor in a compartment housing an engine or generator, nor in a bilge (vapors can travel up the drain line), unless the drain is connected properly to a sealed condensate or show- er sump pump.Failure to comply may allow bilge or engine room vapors to mix with the air conditioners return air and contaminate living areas.

Installation Guidelines for 6K - 16K Condensing Units

When choosing the proper model Condensing Unit, primary consideration should be given to calculated BTU loads and available power supply.Special consideration should be given in determining the reverse cycle heating capacities under anticipated conditions.Reverse cycle operation is affected by the seawater temperature.As it decreases, the unit’s heat transfer capacity also decreases and proportionately affects the output of warm air.It is not recommended that the unit be operated in the heat cycle with water temperatures below 40°F/4.4°C.The location of the

.

In the interest of product improvement, specifications and design as outlined herein are subject to change without prior notice. L-2125