MiniLED Thru-HullSeaLite

®

Replacing LED Cartridge Assembly

1. Ensure the MiniLED Thru-Hull SeaLite
® fitting is cool. 2. Prepare a clean surface near the thru-hull fitting. You will need a clean surface on which to set the replacement LED cartridge assembly. A pad made from several paper towels covering a dry, clean surface works well. 3. Have a small (1/8") flat blade screwdriver within easy reach of where you will work. 4. Ensure that the DC power is turned off. Disconnect the light’s power cable from DC power and gather up the cable run. 5. Using the small flat blade screwdriver, remove the LED cartridge assembly snap ring. Refer to the assembly drawing on page 17. 6. Unthread the LED cartridge assembly and slide it clear of the fitting assembly. 7. The old LED cartridge assembly and power cable should be disposed of appropriately. 8. Inspect the inner diameter of the fitting and the inner surface of the port for any debris. If any contaminants are found, clean with reagent grade isopropyl alcohol. Dry thoroughly using canned air such as Dust-Off
® .9. Begin reassembling the light by gently inserting new LED cartridge assembly into the fitting assembly and thread it into place. Note, the endcap is made of Delrin. Hand tight should be all that is required to ensure a good seal. If a wrench is needed, be careful not to strip or break the endcap. 10. Reinsert the LED cartridge assembly snap ring. If a new LED cartridge assembly is not available to immediately replace the old assembly, cover for boats the fitting opening with several layers of saran wrap cover to help keep the fitting clean inside. Use good quality black electrical tape (such as Scotch 33 or 38) to secure saran wrap in place. Remove the saran wrap cover before installing a new LED cartridge assembly. 11. Ensure that the DC power is turned off. Refer again to the wiring diagrams on page 16 and connect the light’s cable to a properly sized in-line fuse or circuit breaker. Consult a professional marine electrician. WARNING! DO NOT connect MiniLED Thru-Hull SeaLite
® to AC voltage. 12. At this point, the MiniLED Thru-Hull SeaLite
® can be tested by energizing the light. 13
Rev. 3/19/08