Catalogues - 65w-halogen-thru-hull-sealite

Catalogue 65W Halogen Thru-Hull SeaLite®

www.deepsee.com

Page

/ 15

Where to buy
this product ?

Request
a Quote

DeepSea - 62482, 59806, 60050, 63956, 205010

/ 15

See other catalogues for DeepSea

Text version of the page

12-Volt Halogen Thru-Hull SeaLite®

DeepSea Power & Light, Inc

14. DSP&L recommends that the flanges be painted with anti-fouling paint after installation. In addition, spraying the end cap and fitting tube with WD-40 every two months will help inhibit corrosion.

SeaLite® can become very hot even after a short period of operation. They may remain hot enough to cause injury for an extended period after operation.

• After installing the new lamp in the lamp assembly, be sure to clean the glass surfaces of the lamp with reagent grade isopropyl alcohol. Dust, marine oils and other debris including fingerprints on the glass surfaces will significantly reduce the life of the lamp and may cause damage to the fixture once the lamp is energized. Allow 5 to 10 minutes for the alcohol to evaporate from the lamp surface before replacing the assembly in the fixture.

General Operating Instructions

The lamp should only be energized when the flange and front port are fully submerged in water to prevent overheating. Marine lights that are fully submerged while the vessel is at rest may lose direct contact with the water when the boat for boat is underway. In particular, lights mounted on the stern of a vessel may tend to overheat while the boat is underway, even if they are fully submerged. This is due to the high concentration of bubbles in the water directly behind the stern of most vessels when they are underway. Exercise caution when operating the lights while the vessel is underway.

Important Notes

• Always ensure that the DC power is disconnected and locked out before performing any installation or service work on the Halogen Thru-Hull SeaLite.

• The original cable provided by DeepSea Power & Light, Inc. with this fixture has been specifically chosen for the purpose. Substituting another cable for this purpose may result in fire, injury, damage or loss of property and even death. Additional cable is available from DeepSea Power & Light, Inc. (1-800-ITS-DSPL ask for part # 600-00143)

• Warning labels are provided to remind users not to operate the marine lamps unless they are totally submerged. Please attach these next to any marine switches or other points where the lamp may be energized by the end-user.

Re-lamping Important Notes

• Only those lamps specified by DeepSea Power & Light, Inc. should be used for the purpose of re lamping the Halogen Thru-Hull SeaLite®. Please contact DeepSea Power & Light, Inc. for more information (800 487 3775) or to purchase replacement lamps suitable for your fixture. Note: Use of the wrong lamp will damage the fixture.

• The DC power should be off and locked out before any service of the Halogen Thru-Hull SeaLite® is undertaken.

• Re-lamping should only be attempted when the existing lamp is cool. The lamps used in the Halogen Thru-Hull

Rev. A 03/14/07