18LED Thru-HullSeaLite

®

If a new driver assembly is not available to immediately replace the old assembly, cover for boats the fitting opening with several layers of saran wrap cover to help keep the fitting clean inside. Use good quality black electrical tape (such as Scotch 33 or 38) to secure saran wrap in place. Remove the saran wrap cover before installing a new driver assembly. 23. Ensure that the DC power is turned off. Refer again to the wiring diagrams on page 18 and connect the light’s cable to a properly sized in-line fuse or circuit breaker. Consult a professional marine electrician. WARNING! DO NOT connect 18 LED Thru-Hull SeaLite
® to AC voltage. 24. At this point, the 18 LED Thru-Hull SeaLite
® can be tested by energizing the light. 15
Rev. 3/19/08