18LED Thru-HullSeaLite

®

Internal Fuse Replacement

DANGER! Disconnect the DC power before attempting to service the light. Servicing a live light can result in electrocution, fire, personal injury and even death. 1. Disconnect DC power to the light. 2. Loosen the cable seal nut (Heyco) on the end of light fitting inside sailboat boat. Wiggle cable and push in slightly to be certain cable is loose from cable seal nut. 3. With the cable seal nut loosened, start unscrewing the retaining nut (counter clockwise). 4. As the retaining nut is unscrewed, the endcap will be pushed back. As it is, push the cable into endcap gently. 5. When the retaining nut is loose, carefully remove the endcap while pushing in cable so that the cable does not disconnect. 6. Use a digital meter to check the fuse (See Figure 1). Fuse Fig. 1 7. If the fuse is open, replace with an 8 amp fuse. 8. Reassemble the endcap to the fitting and tighten the retaining nut. The inner o-ring is for sealing, so be sure it is clean and without debris. The outer o-ring and the retaining nut is only for vibration lock, not for sealing. The retaining nut is fully installed when this o-ring is not visible. 9. Be certain the outer marine jacket of the cable is fully within the body of the cable seal nut, and protrudes slightly within the interior of the 18 LED Thru-Hull SeaLite. Tighten the cable seal nut and tug on the cable lightly. When the seal nut is fully engaging the cable jacket, the cable will not pull loose or move.10. Reconnect DC power to the light. 11. Test light operation. 13
Rev. 3/19/08