18LED Thru-HullSeaLite

®

10. Use the green screw terminal on the jacking ring to connect the fixture to the ship’s bonding system. Failure to properly ground this fixture may result in catastrophic failure due to CORROSION, which in turn may lead to injury, damage or loss of property and loss of life. 11. DSP&L recommends that the flange of the thru-hull fitting be painted with anti-fouling paint after installation. In addition, spraying the end cap and the portion of the fitting inside the hull with WD-40 every two months will help keep the fitting looking new and free of corrosion. Caution! The original cable provided with this light has been specifically chosen for this application. Substituting another cable may cause improper operation, shock hazard, interference with other marine equipment on the vessel, and can result in damage that may not be covered under warranty. Additional cable is available from DeepSea Power & Light, Inc. by calling 1-800-ITS-DSPL (1-800-487-3775).12. Verify that the light’s voltage rating and the voltage available on the vessel are compatible. Ensure that the DC power is turned off. Refer again to the wiring diagrams on page 16 and connect the light’s cable to a properly sized in-line fuse or circuit breaker. Consult a professional marine electrician. WARNING! DO NOT connect 18 LED Thru-Hull SeaLite
® to AC voltage. 13. At this point, the 18 LED Thru-Hull SeaLite
® can be tested by energizing the light. 10
Rev. 3/19/08