Thru-HullSeaLite

®

150W-HID

Thru-Hull SeaLite

®

Features

Every Thru-Hull SeaLite
® comes with our custom engineered thru-hull fitting and light head. The thru-hull fitting includes several features designed to ensure your safety and enhance your enjoyment of your new Thru-Hull SeaLite
® is specifically designed to run the light’s 150 watt high intensity discharge (HID) boat lamp. The ballast on your 150W-HID includes the following features.
® . Splashproof Enclosure – The ballast is mounted in a NEMA 4X (IP-65) enclosure. This enclosure allows the ballast to be mounted in damp or wet locations, and provides protection for the live ballast connections (HID-O version does not include a ballast enclosure). Sapphire Port – Sapphire is one of the strongest and most abrasion resistant transparent materials available. It will withstand accidental impact better than glass, and is less likely to be damaged by hull cleaning marine equipment. In addition, sapphire transfers heat more efficiently than glass, allowing the light to run much cooler, resulting in longer lamp life. AC Fused – A fuse is included in the ballast enclosure to protect the ballast and the vessel’s electrical system against accidental overloads. Water-tight housing, Front & Back – Front and rear seals provide an extra measure of safety since, in the unlikely event that the sapphire window is broken, the rear seal will contain flooding to the inside of the thru-hull fitting. No water is allowed into the vessel. Shielded Wiring – Shielded cable is used for the AC input and between the ballast and the light head. The shield provides a grounded layer around all current carrying wires to reduce the chance of interference with other systems. In addition to the features shown above, the HID-X version incorporates the following features: UL (Underwriters Laboratories) Recognized – All components of your Thru-Hull SeaLite Thermal Protect Circuit – Automatically shuts off power if the internal temperature of the light head gets to high.
® Flood Detect - Automatically shuts off power in the unlikely event of a flooding. have been tested for safety in the marine environment. Fault Indicator for boat Light – Illuminate in the event of a thermal or moisture issue. Titanium or 316 Stainless Steel Construction – The thru-hull fitting is available in 316 Stainless Steel or in Titanium for enhanced corrosion protection. High Color Temperature Lamp for Enhanced Effect – Your Thru-Hull SeaLite
® projects a whiter, brighter light from its 150 watt, 7500 K color temperature lamp. In addition, the light head’s reflector is specially designed for a 60 beam angle that is wide enough to be useful near the surface, but tight enough beam to achieve good penetration. The ballast on every Thru-Hull SeaLite 6
Rev. B 8/13/07