Thru-HullSeaLite

®

150W-HID Fuse Replacement HID-S Version HID-X Version

DANGER! Disconnect the AC power DANGER! Disconnect the AC power before attempting to service the ballast. before attempting to service the ballast. Servicing a live ballast can result in Servicing a live ballast can result in electrocution, fire, personal injury and even electrocution, fire, personal injury and even death. death. 1. Disconnect or lock out the power to the ballast.2. Loosen the four screws securing the cover for boat of the ballast box and remove the cover. The screws will be retained in the cover. 3. Pull the fuse holder out of the boat terminal strip inside the ballast box. 4. Remove the blown fuse from the fuse holder. 5. Inspect the fuse or test with an ohmmeter, if available. If the condition of the fuse cannot be determined, replace it with a new fuse. 1. Disconnect or lock out the power to the ballast.Note: the fuse is located in a panel for boat mount fuse holder that protrudes thru the ballast box in-between the two cable entry points. 2. Remove the fuse by rotating the fuse cap counter clockwise ¼ turn while pushing in the cap and then pulling straight out. 3. Inspect the fuse or test with an ohmmeter, if available. If the condition of the fuse cannot be determined, replace it with a new fuse. WARNING! A blown fuse must be replaced with a fuse of the same type and current rating. Substituting a different fuse may result in marine equipment damage, fire and personal injury.6. Insert a new fuse of the same type and current rating. WARNING! A blown fuse must be replaced with a fuse of the same type and current rating. Substituting a different fuse may result in equipment damage, fire and personal injury.4. Insert a new fuse of the same type and current rating.
For 120 volt units , use a 3.15A, Fast Acting, 5X20 mm, 250V fuse such as Wickmann 1931315000, or Littlefuse 2173.15 For 240 volt units For 120 volt units , use a 3.15A, Fast Acting, 5X20 mm, 250V fuse such as Wickmann 1931315000, or Littlefuse 2173.15 For 240 volt units , use a 1.6A, Fast Acting, 5X20 mm, 250V fuse such as Wickmann 1931160000, or Littelfuse 21701.6 , use a 1.6A, Fast Acting, 5X20 mm, 250V fuse such as Wickmann 1931160000, or Littelfuse 21701.6 7. Replace the fuse holder in the terminal boat block. Be sure the fuse holder is fully inserted. 8. Replace the ballast box cover and tighten the four cover screws. 9. Reconnect the power to the ballast. 10. Test light operation. 5. Place the fuse in the end cap and insert into fuse holder. 6. Rotate 1/3 turn clockwise to secure fuse cap to fuse holder. 7. Reconnect the power to the ballast. 8. Test light operation. 21
Rev. B 8/13/07