VDL 6000/FASS - 2 Pages

  1. P. 1

  2. P. 2

Catalogue excerpts

The AIS Shore Station – VDL 6000/FASS fulfills requirements of international AIS standards and provides all the features required for Features vessel traffic surveillance. extended The SOTDMA technology used in the AIS transponder broadLow power consumption This information includes drastically within VHF coverage. and alternative power sourcesposition, limit the need for infrastructure investments. casts and receives information about all AIS equipped vessels identity, course and speed over ground, heading, navigational Features status and destination. The VDL 6000/FASS can be factory configured to support several features. The information received is easily plotted on an electronic chart display system. provides a number of functions, The AIS Base Station This gives a surveillance capability that was not possible prior totargets by selection of MSG type including filtering of AIS AIS. AIS information is also useful in and/or filtering of a defined area. The AIS Base awareness. rescue operations with the increased situational Station can be equipped with dual antennas. Configuration and Interfaces The AIS Airborne transponder, to function as receive-only The AIS Base Station can be setwith its internalaGPS, connects base station. to power supply, VHF and GPS antennas and to a laptop with configuration software. The same laptop or a CDTI can also run The AIS Base Station is also available as a Repeater Station, an electronic chart system at remote and isolated locations. which is an ideal gap-filler to display targets received by the AIS dual antenna configuration allows the Repeater station to The Airborne transponder. receive and transmit on directional antennas. This greatly improves coverage and distance in an AIS network. The VDL 6000/FASS, factory configured as Repeater station, is the perfect choice when implementing an AIS network where extended coverage at remote locations is required. The VDL 6000/FASS can be factory configured as the following base station types: - AIS Base Station (can be set as receive-only) - Repeater Base Station - AtoN Base Station The AIS Base Station can be factory configured to support AtoN features. The AtoN Base Station is capable of storing one Real AtoN station and multiple (up to 20) Virtual or Synthetic AtoN stations in its AtoN database. The AtoN database also contains aids-to-navigation report transmission schedules for each AtoN station.

 Open the catalogue to page 1

VDL 6000/FASS Technical Specifications Power Input voltage Power consumption 100 – 240 V AC, 50 – 60 Hz and/or +24 V DC Idle 15 W, Nominal 25 W, Max 40 W Radio Transmitter output power (adjustable) Receiver sensitivity, 20% MER Bandwidth Protocol Baud rate Modulation Frequencies Default channels 12,5 W / 1 W, 50 Ohm load < - 107 dBm 25 kHz TDMA (AIS) 9600 bps (AIS) / 1200 bps (DSC) GMSK (AIS) / FSK (DSC) 156.025 MHz – 162.025 MHz 87B (161.975 MHz) 88B (162.025 MHZ) 70 (156.525 MHz) GNSS Receiver GPS DGNSS support L1, 16 parallel channels NMEA via network Base Station Feature AIS base station Repeater...

 Open the catalogue to page 2

All C.N.S. Systems AB vertreten durch ELNA catalogues and brochures

  1. Aldebaran III

    2 Pages

    En
  2. DataSwitch

    2 Pages

    En
  3. Pegasus

    2 Pages

    En
  4. Sentinel

    2 Pages

    En
  5. Maestro

    2 Pages

    En
  6. DataStore

    2 Pages

    En
  7. Horizon

    2 Pages

    En
  8. Aldebaran II

    2 Pages

    En