| Override - Hooked In The security system can be operational when the rider is either hooked in to the harness loop or unhooked (with an attached leash). If a rider chooses the hooked in option, they must use and Cabrinha harness loop with security pin. Override - Unhooked The security system can be operational when the rider is either hooked in to the harness loop or unhooked (with an attached leash). If a rider chooses the unhooked in option, they must use a Cabrinha Bypass leash attached to the Harness loop. The Override Stopper Unit is a convenience item that allows the rider to un-spin the bar after rotations without fully depowerinp the kite. It it set up at the factory with a release load of approximately 10kg. When adequate force is applied, the bar will push past the Override Stopper Unit into Override mode. The release load can be increased incrementally by the rider using the supplied tension ring. To increase the release load of the Stopper Unit, squeeze the tension ring until it tightens around the Stopper unit. As the ring tightens, it will ratchet incrementally so that you can choose your preferred level of release. CAUTION: The tighter you tension the ring the more force it will take to unseat the Override Stopper Unit from its sleeve. We suggest you start with the lowest release setting until you are familiar with the operation of Override. ■ _l_ 18 |