Quart Steadi-Grip Pressure Container - 4 Pages

Add to MyNauticExpo favorites
Quart Steadi-Grip Pressure Container

Catalog excerpts

In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows: Hazards or unsafe practices which could result in severe personal injury, death or substantial property damage. Hazards or unsafe practices which could result in minor personal injury, product Important installation, operation or maintenance information. Read the following warnings before using this equipment. Before operating finishing equipment, read and understand all safety, operation and maintenance information provided in the operation manual. WEAR SAFETY GLASSES...

 Open the catalog to page 2

Binks Model 80-295 (2 QT.) "STEADI-GRIP" PRESSURE CONTAINER PARTS LIST When ordering, please specify Part No. ITEM PART (ORDER SEPARATELY) AIR CONTROL) (ORDER SEPARATELY) * Available in quantity pack. ForTri-Seal Gaskets, order 80-11-5 (qty. of 5). A Available from Industrial Finishing distributors only.

 Open the catalog to page 3

External Mix Air Nozzle Application 1. Connect hose as shown in diagram on front page. 2. Fill cup with strained fluid mixed in accordance with manufacturer's recommendations on label of container. 3. Fasten cover securely. 4. Close air adjusting valve by turning clockwise. 5. Set air pressure at CleanAir filter unit to between 35 and 80 PSI, depending upon atomization desired. 6. Set regulator on pressure cup to approximately 10 PSI for enamels; 5 PSI for lacquers. (Turn knob clockwise to increase pressure; to reduce pressure, turn knob counter-clockwise. Always release air in cup by...

 Open the catalog to page 4

All Binks catalogs and brochures

  1. Trophy Siphon

    80 Pages

  2. Trophy Gravity

    80 Pages

  3. Trophy Pressure

    80 Pages

  4. GEMS 240-5100

    16 Pages

Archived catalogs

  1. Trophy series

    10 Pages