| Switching Nitrox Mixes QjS^3 Note: Instructions for setting Mix 1 and Mix 2 are found on page 15 & 16. To switch between Mix 1 to Mix 2, press A for 3-4 seconds. When the A button is initially pressed, the Quantum will show the new no-decompression limit (NDL) and P02 based on the mix being selected. For example, if the Quantum is set to Mix 1 and you press the A button, it will show the NDL and P02 based on Mix 2. If the P02 is below 1.6, the Quantum will allow the switch to the new mix; however, if the P02 is 1.6 or higher, the P02 and iwr-t label will flash and the Quantum will not allow the switch. If the mix is set to default (- - %), the Quantum will not allow the switch to the new mix. |